Parmco HX-2-2NF-INDUCT, Инструкция по установке и эксплуатации

Страница: 25 / 28

22
Before you install the hob, make sure that
• the work surface is made of a heat - resistant material.
• if the hob is installed above an oven , the oven has a built - in cooling fan.
• the installa � on complies with all clearance requirements and New Zealand standards and
regula � ons.
•
a suitable isola � ng switch providing full disconnec � on from the mains power supply is
incorporated in the permanent wiring , mounted and posi � oned to comply with the local
standards and regula � ons.
• the isola � ng switch must be of an approved type and provide a 3 mm air gap contact
separa � on in all poles ( or in all ac � ve [phase] conductors if the local wiring rules allow for
this varia � on of the requirements ) .
•
the isola � ng switch will be easily accessible to the customer with the hob installed.
• consult local building authori � es and by - laws if in doubt regarding installa � on.
• heat - resistant and easy - to - clean fi nishes ( such as ceramic � les ) are used for the wall
surfaces surrounding the hob.
• the power supply cable is not accessible through cupboard doors or drawers.
• there is an adequate fl ow of fresh air from outside the cabinetry to the base of the hob.
•
if the hob is installed above a drawer or cupboard space , a thermal protection barrier is
installed below the base of the hob.
•
the isola � ng switch is easily accessible.
A(mm) B(mm) C(mm) D E F G
650 50 min 20 min Air intake Air e x it ≥ 5mm > 35 mm <50mm
D
E
A
C
B
>2cm
F
G