Installation
Selection of Installation Equipment
Cut out a hole in the table surface according to the sizes shown in the diagram. For
the purpose of installation and use, a minimum of 50mm space must be
preserved around the hole.
Be sure the thickness of the table surface is at least 30mm. Please select
heat-resistant table material to avoid larger deformation caused by the heat
radiation from the hotplate.
As shown in Figure (1).
Make sure the hob is well ventilated and that there are no obstructions
between the hob and the ventilation system.
Upon installation, inspect your hob to ensure it is in good working state.
min 650mm
Air exit
min 5 cm
min 2 cm
Air intake
min 5 mm
Figure (2)
