EN
Your Spektrum DX4e comes prebound to the aircraft.
Remove the battery cover, install the four included batteries (noting proper
polarity) and reinstall the battery cover.
Low Battery Alarm
When the battery voltage drops below 4.7 volts, an alarm sounds and the
voltage LEDs fl ash. The batteries must be replaced immediately. If this
happens while fl ying, land your aircraft as soon and as safely as possible.
1
3
2
Installing the Transmitter Batteries
Trainer/Bind Button ((C) Mode 1 or (R) Mode 2)
The Trainer/Bind Button is used during binding or when connecting a trainer
cord (SPM6805) to the trainer port (
T
). For complete binding instructions, refer
to the binding section in this manual.
When using the trainer function, connect the trainer cord into the trainer port
in both the master (instructor) and the slave (student) transmitters. The master
transmitter must be powered ON and bound to the receiver. The slave trans-
mitter must be powered OFF. Any time you press and hold the trainer button
on the master, it will give control authority to the slave. Releasing the trainer
button returns control to the master.
IMPORTANT:
The slave transmitter must always have the same reverse set-
tings as the master.
Hi/Lo Rate Switch (D)
This switch supports high and low rate functions on aileron, elevator and
rudder channels. In the upper, or “HI” position, servo travel is 100% on these
channels. In the lower, or “LO”, position, servo travel decreases to 70% on
these channels. This switch lets you quickly change control rates from high for
aggressive maneuvers to low for smooth, precise maneuvers. When learning
to fl y, use low rate.
Mode Switch (I)
This switch changes channel assignments to the control sticks. Always ensure
the controls respond as desired before fl ying. A Mode 1 transmitter may be
switched to Mode 3, while a Mode 2 transmitter may be switched to Mode 4.
Mix Switch (J)
This switch enables a mix for elevons on Delta wing aircraft. If needed, refer
to the transmitter manual for more information.
C
R
A
B
D
E
F
G
H
I
J
K
L
M
N
O
P
Q
S
T
KEY
A
Antenna
B
Handle
C
Trainer/Bind Button (Modes 1/3 only)
D
Hi/Lo Rate Switch
E
Right Control Stick
F
Trim Slider (for up/down on stick)
G
Neck Strap Connection
H
Trim Slider (for left/right on stick)
I
Mode Switch (1/3 or 2/4)
J
Mix Switch (Elevon only)
K
Servo Reverse Switches
L
Power Switch (ON/OFF)
M
Trim Slider (for left/right on stick)
N
Trim Slider (for up/down on stick)
O
Left Control Stick
P
LEDs
Q
ACT/AUX Switch (Channel 5)
* The diagram shows the transmitter controls for Mode 2 and Mode 1 transmitters.
R
Trainer/Bind Button (Modes 2/4 only)
S
Battery Cover
T
Trainer Port
Understanding the Controls of the DX4e Transmitter
For more information on the transmitter, go to
http://www.horizonhobby.com/products/
dx4e-dsmx-4-channel-full-range-tx-only-
md2-4-SPMR4400
and click on the support
tab for the Spektrum DX4e to download the
instruction manual.
5
