Parkside PTMI 180 A1, Руководство пользователя

Страница: 17 / 57

GB/IE/CY 17
z
TIG welding
Make sure that the ON/OFF switch
9
is set to position “O” (“OFF”) or that the mains cable
8
is not
plugged into the socket.
„
To do this, connect the connector of the earth terminal
4
with the relevant output on the inverter
welder (marked with “+”).
„
Connect the connector of the TIG torch with the relevant output on the inverter welder (marked
with “-”).
„
Put on appropriate protective clothing in accordance with the specifications and prepare your
workplace.
„
Connect the earth terminal
4
to the workpiece.
„
Connect the gas inlet of the torch with the appropriate outlet of your pressure reducer (not part of the
scope of delivery). Use Argon as the inert gas. A gas flow of at 4–8 l / min is recommended.
„
Switch the device on by setting the ON/OFF switch
9
to the “I” (“ON”) position.
„
Adjust the welding current using the control wheel
3
depending on the electrode being used.
„
Select the “0.0” position by pressing the control button
2
several times and rotating the control
wheel
3
if necessary. Continue to press the control button
2
until the “LiftTIG 6/6” menu item is
displayed. Select the “ON” setting by rotating the control wheel
3
. Confirm by pressing the control
button
2
. You can now set the welding current by rotating the control wheel
3
.
z
Maintenance and cleaning
NOTE: The welder must be regularly serviced and overhauled for proper function and for compliance
with the safety requirements. Improper and wrong operation may cause failures and damage to the
device.
„
Before performing cleaning work on the welding tool, disconnect the mains cable
8
from the power
outlet to ensure the device is safely isolated from the power supply.
„
Clean the exterior of the welder and its accessories regularly. Use compressed air, cotton waste or a
brush to remove dirt and dust.
NOTE: The following kinds of maintenance work must be performed only by suitably-qualified
personnel.
„
The current regulator, earthing device and internal cables must be serviced regularly.
„
Check the insulation resistance levels of the welder regularly. To do this use an appropriate
measuring device.
„
In case of a defect or a necessary replacement of equipment parts, please contact the appropriate
qualified personnel.
z
Information about recycling and disposal
DON’T THROW AWAY – RECYCLE!
According to European Directive 2012/19/EU, used electrical devices must be collected
separately for environmentally compatible recycling or recovery. Please return this device to an
approved waste management company or use your municipal waste collection service. Please ensure
you comply with local regulations. If you have any questions, please contact your local authority or
waste management company.
Please return this device, accessories and packaging to your local recycling depot.
Do not dispose of electrical appliances in household waste! This satisfies your legal obligations
while also making an important contribution to protecting the environment.