GB
31
children to play with the device. Cleaning and day-to-day mainte-
nance must not be performed by children without supervision.
Repairs and/or maintenance work must only be carried out by
qualified electricians.
Only use the cutting cable provided in the scope of delivery.
During operation, the device should not be positioned directly
against the wall, covered or jammed between other devices so
that sufficient air can always be absorbed through the ventilation
slats. Make sure that the device is correctly connected to the supply
voltage. Avoid any form of tensile stress of the power cable.
Disconnect the mains plug from the socket prior to setting up the
device in another location.
If the device is not in operation, always switch it off by pressing
the ON/OFF switch and lock the interlock switch. Place the burner
on an insulated surface and only carry out maintenance work after
allowing it to cool down for 15 minutes.
Hot metal and sparks are blown off from the cutting arc. The flying
sparks, hot metal as well as hot objects and hot device equipment
can cause fires or burns. Check the working environment and make
sure the workplace is suitable prior to using the device.
Remove all flammable material within 10 m of the plasma cutter. If this
is not possible, cover the objects meticulously using suitable covers.
Do not make cuts in places where flying sparks could come into
contact with flammable material.
Protect yourself and others from flying sparks and hot metal.
Please be careful because sparks and hot materials can easily
fall through small gaps and openings while cutting and land on
adjacent areas.
Please be aware that cutting on a ceiling, floor or a partition can
cause a fire on the opposite side that is not visible.
Connect the power cable using the shortest route with a socket
situated close to the workplace to prevent the power cable from
being spread across the whole room and located on a surface
which could cause an electric shock, sparks or fire outbreak.
Do not use the plasma cutter to defrost frozen tubes.
RISK OF ELECTRIC SHOCK:
ELECTRIC SHOCK FROM THE CUTTING
ELECTRODE CAN BE FATAL.
Do not use the plasma cutter when it is raining or snowing.
Wear dry insulating gloves.
