Parkside PMFAP 20-Li A1, Инструкция по эксплуатации

Страница: 24 / 304

PMFAP 20-Li A1
GB
│
IE
│
11
■
Re-adjusting the routing depth
♦ The routing depth can be readjusted using the
dial .
♦ Release the clamping lever by turning it
clockwise. Push the appliance downwards until
the depth stop rests against the step stop .
♦ Lock the clamping lever by turning it anti-
clockwise.
♦ Undo the locking screw . Use the dial to
adjust the routing depth adjustment scale (depth
stop) so that you can set the exact zero
point, for example. Retighten the locking screw
.
♦ Release the clamping lever by turning it
clockwise and raise the appliance again. Check
the routing depth by means of another practical
test.
Setting the routing depth with the
step stop
NOTE
► The step stop can be used for greater
routing depths in several stages with less chip
removal.
♦ Set the desired routing depth to the lowest step
(0 mm) of the step stop (as described
above).
♦ Then set the higher levels for the first machining
steps.
♦ Check the routing depth by means of a practical
test.
Routing direction
The router must always be moved against the
direction of rotation of the router bit (up cut).
ATTENTION! When routing in the direction of
rotation (down cut), the power tool can be ripped
out of your hand.
Routing operation
Adjust the desired routing depth as described
above.
♦ Place the appliance onto the workpiece and
switch it on.
♦ Release the clamping lever by turning it
clockwise. Push the appliance downwards until
the depth stop rests against the step stop .
♦ Lock the appliance by turning the clamping
lever anticlockwise.
♦ Carry out the routing process at a uniform
speed and contact pressure.