Parkside PMFAP 20-Li A1, Инструкция по эксплуатации

Страница: 16 / 304

PMFAP 20-Li A1
GB
│
IE
│
3
■
Fig. C
Roundover bit Ø 22 mm / R 6.3 mm
Ogee bit Ø 25 mm / R 4 mm
Cove bit Ø 22 mm / R 6.3 mm
V-groove bit Ø 12.7 mm / angle 90°
Straight bit Ø 6 mm
Straight bit Ø 12 mm
Package contents
1 cordless multifunctional router 20V
1 open-ended spanner
1 collet chuck 6 mm
1 collet chuck 8 mm (mounted)
2 extraction nozzles
1 parallel fence
1 router bit set, 6 pieces
1 routing module
1 angle routing module
1 edge routing module
1 set of operating instructions
Technical specifications
Rated voltage 20 V (DC)
Rated idle speed n
0
10000–30000 rpm
Level 1 = 10,000 rpm
Level 2 = 14,000 rpm
Level 3 = 18,000 rpm
Level 4 = 22,000 rpm
Level 5 = 26,000 rpm
Level 6 = 30,000 rpm
Max. operating speed
(router bit)
n
max
35000 rpm
Router cage stroke 0–40 mm
Cutting range 0–35 mm
Tool holder 6/8 mm
Battery PAP 20 B3*
Type LITHIUM ION
Rated voltage 20 V (DC)
Capacity 4 Ah
Cells 10 (80 Wh)
High-speed battery charger PLG 20 C3*
INPUT
Rated voltage 230–240 V ∼ 50 Hz
(AC)
Rated power
consumption 120
W
Fuse (internal) 3.15 A
T3.15A
OUTPUT
Rated voltage 21.5 V (DC)
Rated current 4.5 A
Charging time approx. 60 minutes
Protection class II / (double insulation)
* BATTERY AND CHARGER ARE NOT SUPPLIED
Noise emission value
Noise measurement value determined in
accordance with EN 62841. The A-rated
noise level of the power tool is typically:
Sound pressure level
L
pA
= 79.2 dB (A)
Uncertainty K
pA
= 3 dB
Sound power level L
WA
= 90.2 dB (A)
Uncertainty K K
WA
= 3 dB
Wear hearing protection!
Vibration emission value
Total vibration values (vector sum of three direc-
tions) determined in accordance with EN 62841:
Hand/arm vibration
a
h
< 2.5 m/s 2
Uncertainty K = 1.5 m/s 2
NOTE
► The vibration emission values and the noise
emission values given in these instructions
have been measured in accordance with a
standardised test procedure and can be used
for comparison of the power tool with another
tool.
► The specified total vibration values and the
noise emission values can also be used to
make a provisional load estimate.