Parkside PHSA 20-Li B2, Перевод оригинальной инструкции по эксплуатации и безопасности

Страница: 21 / 134

19 GB
Switching the product on
Check that the battery pack
[ ]
is in place
(see “Attaching/removing the battery
pack”).
Press and hold the safety switch [ 4] at the
front handle
[ 5]
.
Press and hold the on/off switch [ 7] . The
product runs at top speed by default.
Switching the product off
Release the safety switch
[ 4]
or the on/off
switch [ 7] .
z Working instructions
m WARNING! RISK OF INJURY!
X
When operating the product, do not
make contact with solid objects, e.g. wire
fences or main plant stems. You could
otherwise loose control over the product.
X
If the safety knife bar
[ 2]
gets jammed
by solid objects: Turn the product off
immediately and remove the battery-pack
[ ] . Only then should you remove the
object.
X
Avoid overstraining the product during
work.
m
CAUTION! RISK OF PRODUCT
DAMAGE!
X
Before use, check that the edge of the
safety knife bar
[ 2] is sharp. A blunt edge
can overstress and damage the product.
Damages caused by cutting with a blunt
edge are not covered by the warranty
(see “Maintenance”).
z Cutting techniques
Before operating the product: Use branch
clippers to cut away thick branches.
The safety knife bar [ 2] enables cutting in
both directions.
Vertical cutting: Move the product uniformly
forward or up and down (Fig. E).
Horizontal cutting:
–
Tilt the product so that the safety blade
shaft
[ 2] is pointing downwards by
approx. 0 to 10° in cutting direction.
With the product in this position,
move the product horizontally — not
downwards (Fig. H).
–
Move the product in a sickle-shaped
movement to the edge of the hedge, so
that cut branches fall to the ground.
To produce long straight lines: Place
guiding cords as an aid for orientation.
Cutting shaped hedges
Cut hedges in a trapezoidal shape, in order
to prevent stripping off the lower branches
(Fig. G). This corresponds to natural plant
growth and allows the hedge to thrive.
When cutting, only reduce new annual
growth. This facilitates a dense branching.
Cut the sides of a hedge first. To do this,
move the product in the direction of growth
from bottom to top. If you cut down from
the top, the thinner branches will move out,
which may result in some areas having
sparse growth or holes.
Cut the top edge, according to taste, in a
flat shape, roof shape or rounded shape
(Fig. F).