Parkside PHKS 1350 C2, Оригинальное руководство пользователя

Страница: 14 / 46

GB
│
IE
│
NI
│
CY
│
11 ■ PHKS 1350 C2
Switching the laser on and off
Switching on
♦ Press the ON/OFF switch laser .
Switching off
♦ Press the ON/OFF switch laser .
NOTE
► If the batteries are spent, replace them with
two new 1.5 V alkaline button cells (type
AG 13/LR 44, e.g. GPA 76) .
Set rotational speed
■ Turn the adjusting wheel to the desired
rotational speed (arrow marking ▲)
(1 = lowest rotational speed/
6 = highest rotational speed):
Use the following suggested settings or set the
rotational speed on the adjusting wheel as
required.
Material
Rotational
speed
setting
Cross cuts & longitudinal cuts in
hard and soft wood (solid wood)
6
Chipboard, fibre board 6
Core board, plywood 6
Coated and veneered boards 6
PVC sheets 3 – 5
Acrylic glass sheets, perspex 2 – 4
Aluminium plate 4 – 6
Aluminium profile 4 – 6
Plaster board 1 – 2
Stone wool board 1 – 2
Cement-bonded particle board 1 – 2
Tips and tricks
■ Avoid damaging the cutting edge of sensitive
materials, e.g. coated chipboards or doors, by
sticking masking tape along the cutting line.
Another benefit of this is that it is easier to mark
a line on the tape than on a shiny surface. An
even more effective method of protecting the
cutting edges is to clamp a thin piece of wood
along the cutting line (this wood is also sawn).
Maintenance and Cleaning
WARNING! RISK OF INJURY!
Switch the appliance off and remove
the power plug before starting any
work.
■ The appliance must always be kept clean, dry
and free from oil or grease.
■ To clean the casing, use a soft dry cloth.
■ The blade guard must always move freely and
close automatically. Therefore, keep the area
around the blade guard clean at all times.
Remove dust and chips by blowing them out
with compressed air or with a brush.
WARNING!
■ If the connecting cable needs to be replaced,
this must be carried out by the manufacturer
or his representative in order to avoid safety
hazards.