30 GB
Preparing for use
General safety advice for electrical power tools / Preparing for use
Fix and secure the work piece to a stable sur-
face using clamps or other means. When only
securing the work piece by hand or against
your body it will remain unstable, which could
lead to loss of control.
Q
Original accessories / attachments
Use only the accessories and attach-
ments detailed in the operating instruc-
tions.
The use of attachments or accessories
other than those recommended here could lead
to you suffering an injury.
Q
Preparing for use
Q
Switching On / Off
Switching on:
First press the safety lock-out
1
.
Then press and keep pressed the ON / OFF
switch
2
.
Switching off:
Release the ON / OFF switch
2
.
Note:
For safety reasons the ON / OFF switch
2
cannot be locked in the ON position.
Q
Setting the cutting depth
The rotary control
13
can be used to set the cutting
depth in steps from 0–3.0 mm according to the cut-
ting depth scale
14
.
Q
Vacuum extraction of dust /
debris (see Fig. A)
DANGER OF INJURY!
Before you carry out any work on the device always
pull the mains plug out of the mains socket.
Planing debris removal port (right / left
selectable):
Release the planing debris removal port
3
by
turning it against the direction of the arrow (out
of the “Lock” position).
Pull the planing debris removal port
3
out of
the device.
The planing debris removal port
3
can be set
to face left or right in the planer.
Push the planing debris removal port
3
into
the device.
Lock the planing debris removal port
3
by
turning it into the “Lock” position.
External vacuum extraction:
If necessary fit the reducer piece
15
when using
a dust extraction system, e.g. a workshop dust
extraction system.
The vacuum cleaner / dust extraction device used
must be suitable for the material being planed.
Connection:
Place the reducer piece
15
firmly on to the
planing debris removal port
3
.
Push the hose of a suitable dust extraction device
approved for that purpose (e.g. a workshop
vacuum cleaner) on to the planing debris remov-
al port
3
or the reducer piece
15
.
Removal:
Pull the hose of the dust extraction device off
the planing debris removal port
3
or off the
reducer piece
15
.
Pull off the reducer piece
15
, if fitted.
Q
Parking shoe (see Figs. B / C)
The parking shoe
16
allows you to lay the device
down without the risk of damaging the workpiece.
When planing, the parking shoe
16
swings up and
exposes the rear part of the sole
9
.
