Parkside PDSS 16 A1, Перевод оригинальной инструкции, Страница: 22 / 192

PDSS 16 A1
GB│CY
│ 19 ■
Maintenance and cleaning
WARNING! RISK OF INJURY!
Disconnect the tool from the compressed air supply.
CAUTION!
► Before maintenance, clean off any hazardous substances that
may have accumulated on the tool (due to working processes) .
Avoid all skin contact with these substances . If the skin comes
into contact with hazardous dusts, this can lead to severe
dermatitis . If dust is produced or swirled up during
maintenance, it can be inhaled .
NOTE
► To ensure correct functioning and a long service life for the
tool, pay attention to the following points:
■ Sufficient and continuous oil lubrication is highly important for
optimum functioning .
■ Check the speed and vibration levels after each use .
■ Check the idle speed regularly and after any maintenance is
performed: use a rev counter and perform the measurement
without any clamped tools . At a residual pressure of 6 .3 bar, the
idle speed may not be exceeded under any circumstances .
■ If the tool is exhibiting excessive vibration levels, the cause of the
vibrations must be identified and repaired .
■ Use only the genuine replacement parts recommended by the
manufacturer, otherwise you could put users at risk . In doubt,
contact the Service Centre .
■ Clean the tool with a soft, dry cloth only .
■ Never use sharp or abrasive cleaning agents under any
circumstances .