Parkside PBSD 900 A1, Перевод оригинальной инструкции

Страница: 10 / 114

GB
│
IE
│ 7 ■ PBSD 900 A1
Fitting the dust collector
♦ Push the dust collector onto the dust collector
connection from above .
Dismantling/removing the dust collector
♦ Pull the dust collector off upwards .
Connecting a dust extraction adapter and
reducer for an external extraction appliance
♦ Push the dust extraction adapter onto the
connection .
♦ Push the reducer for the dust extraction
adapter into the adapter fitting .
♦ Push the hose from a suitable dust extraction
appliance (e .g . a workshop vacuum cleaner)
onto the reducer for external vacuum
extraction .
Removing the dust extraction adapter and
reducer for an external extraction appliance
♦ Pull off the hose of the dust extraction
appliance .
♦ Remove the reducer for external dust
extraction .
♦ Pull the dust extraction adapter upwards
off the connection .
Working procedures
A light grinding pressure is sufficient
■ Apply minimal pressure when grinding . The belt
grinder's own weight is sufficient for a good
grinding result . In addition, working this way
helps to reduce the wear on the abrasive belt
and the surface of the workpiece will become
more smooth .
Removal and surface
■ The material removal rate and surface quality
are determined by the belt speed and grain
strength of the abrasive belt (see also the
section "Selecting speed and abrasive belt") .
Grinding
■ Place the appliance on the workpiece when
switched on and work at a moderate feed rate .
Guide the grinder in parallel and overlapping
sanding motions over the workpiece . To avoid
unpleasant transverse grinding marks, always
sand in the direction of the grain .
After completing the task, lift the appliance from
the workpiece and then switch it off .
NOTE
► Always hold the appliance firmly with two
hands while working .
Use
Switching on and off
While operating the belt grinder, you can choose
between instantaneous and continuous operation .
Switching to instantaneous operation
♦ Press the ON/OFF switch .
Switching off instantaneous operation
♦ Release the ON/OFF switch .
Switching to continuous operation
♦ Press the ON/OFF switch , keep it pressed
in and then press the lock button .
Switching off continuous operation
♦ Press the ON/OFF switch and then
release it .
Emptying the dust collector
The dust collector should be emptied after every
10 minutes of operation at least .
♦ Pull the dust collector off ( see section
"Attaching/removing a dust extraction unit" )
♦ Shake the dust collector over a rubbish
bin to empty it .
♦ Fit the dust collector back onto the
appliance .