Parkside PBF 400 A1, Инструкции по эксплуатации и безопасности

Страница: 9 / 32

9 GB
General power tool safety warnings / Start-up General power tool safety warnings
When undertaking prolonged sanding of wood,
and in particular when working on materials
that give rise to dusts that are hazardous to
health, the sander must be connected to a
suitable external dust extraction device.
Ensure that there is adequate ventilation when
working on plastic, paint, varnish etc.
The band file is designed for dry grinding wood,
plastic, metal and filler, as well as painted sur-
faces. Only use the device for dry grinding.
Do not sand materials containing asbestos.
Asbestos is a known carcinogen.
Sanding e.g. lead paint,
some types of wood and metal can release
harmful / toxic dust. Touching or breathing in
these dusts can present a danger to the user or
persons nearby. Use suitable personal protec-
tive equipment such as dust mask, etc. to prevent
this risk.
POISONOUS DUSTS!
Sanding paints containing lead, some types of
wood and metal for example may give rise to
hazardous or poisonous dusts and represents a
risk to the health of the person operating the
device and to anyone near the work area.
Wear safety glasses and a dust protection mask!
Securely support the workpiece. Use clamps or
a vice to grip the workpiece firmly. This is much
safer than holding it with your hand.
never support yourself by placing your hands
near or in front of the device or the workpiece
surface. A slip can result in injury.
If a dangerous situation arises, pull the mains
plug immediately out of the mains socket.
Always work with the mains lead leading
away from the rear of the device.
Avoid contact with the moving sanding belt.
Do not work on moistened materials or damp
surfaces.
Always switch on the device before placing it
against the workpiece. After sanding, lift the de-
vice from the workpiece before switching it off.
When working always hold the device securely
with both hands. Always keep proper footing
and balance.
Switch the device off and allow it to come to
a complete standstill before you put it down.
When taking a break from your work, before
carrying out any tasks on the device itself (e.g.
changing the sanding belt) and when you are
not using the device, always pull the mains plug
out of the mains socket.
Start-up
Note: the small grinding frame
12
is designed for
fine jobs, cutting and carving (see Fig. E).
The large grinding frame
8
is suitable for general
applications, slotting and making joints (see Fig. F).
The angled grinding frame
13
is suitable for groov-
ing and sanding the middle of the work piece and
confined areas. Also use it to smooth bent areas
(see Fig. G).
Installing the grinding frame
Attach the desired grinding frame
8
,
12
,
13
.
Insert the spring
14
into the mounting hole.
Tighten the adjusting screw
7
on the device
until the grinding frame
8
,
12
,
13
is in line
with the tool (see Fig. A).
Changing the grinding frame
RISK OF INJURy!
Always un-
plug from the mains before working on the band file.
Unscrew the adjusting screw
7
from the device.
Be sure not to lose the spring
14
.
Remove the grinding frame
8
.
Remove the spring
14
.
Insert the spring
14
into the mounting hole.
Attach the desired grinding frame
12
,
13
.
Tighten the adjusting screw
7
on the device
until the grinding frame
12
,
13
is in line with
the tool (see Fig. A).