Parkside PASS 50 A1, Инструкции по эксплуатации и безопасности

Страница: 7 / 33

7 GB/IE/NI
General safety
instructions
BEFORE USING THE PRODUCT, PLEASE FA-
MILIARISE YOURSELF WITH ALL OF THE
SAFETY INFORMATION AND INSTRUCTIONS
FOR USE! WHEN PASSING THIS PRODUCT
ON TO OTHERS, PLEASE ALSO INCLUDE ALL
THE DOCUMENTS!
DANGER TO LIFE AND ACCI-
DENT HAZARD FOR TODDLERS
AND SMALL CHILDREN!
Never
leave children unattended with the packaging
material. The packaging material represents a
danger of suffocation. Children frequently un-
derestimate the dangers. Please keep the prod-
uct out of the reach of children at all times.
This product may be used by children age
8 years and up, as well as by persons with re-
duced physical, sensory or mental capacities,
or lacking experience and/or knowledge, so
long as they are supervised or instructed in
the safe use of the product and understand
the associated risks. Children should not be
allowed to play with the product. Cleaning
and user maintenance should not be per-
formed by children without supervision.
DANGER OF SUFFOCATION! Children
could swallow and choke on small included
parts (e.g. screws). Keep children away from
the work area during assembly.
This product does not contain any parts that
can be serviced by the user. The LEDs cannot
be replaced by end user.
If the LEDs fail at the end of their lives, they must
be repaired by qualified electrician or the
entire product must be replaced.
The external flexible cable or cord of this
product cannot be replaced; if the cord is
damaged, the product shall be destroyed.
Danger to life
by electric shock
Always check the product for damage before
connecting it to the mains. Never use the
product if it shows any signs of damage.
Protect the mains cable against sharp edges,
mechanical stresses and hot surfaces.
Always unplug the mains plug from the socket
before cleaning.
Disconnect the product from the mains supply
if it is not going to be used for some time (e.g.
holiday).
Verify that the mains voltage on site corre-
sponds with the operating voltage required
for the product (230 V∼ 50 Hz), before you
use it. Otherwise do not use the product.
CAUTION! DANGER OF BURN INJU-
RIES!
To prevent burns, verify the product is
switched off and has cooled down for at least
15 min before touching it. The product can
become very hot.
The accessible surface, is very hot when the
lamp is operating.
1 .0 m
FIRE HAZARD! Place the prod-
uct so that it is at least 1.0 m away
from the material to be illuminated.
Excessive heat can result in a fire.
The product is only suited for use with the
built-in LED control gear.
The product continues to draw a small amount
of power even if the product is off as long as
product is connected to supply mains. To
switch the device off completely, unplug the
plug
3
from socket.
The plug can only be connected with a corre-
sponding socket with the same IP in order to
keep the protective degree against dust/ water.
For HG06704-BS, plug for indoor use only.
Luminaires shall not be connected after each
other.
The work light
1
can be hanged up or it can
be used on a flat, stable surface, e.g. floor or
table.