Parkside PAMFW 12 E4, Руководство пользователя

Страница: 21 / 72

19 GB
˜
Charging the battery pack
(Fig. B)
m CAUTION!
u
Always disconnect the power plug
[ 19]
from mains before removing the battery
pack
[ 2]
from the charger
[ 16]
.
u
Connecting the power plug
[ 19]
to mains
before inserting battery pack
[ 2]
to
charger
[ 16]
NOTE
u
Battery pack
[ 2]
is partially charged.
Charge it completely before first use.
u
Battery pack
[ 2]
can be charged at any
time as needed without shortening its
service life.
u
Interrupting the charging process does not
damage the battery pack
[ 2]
.
u
Never charge the battery pack
[ 2]
if the
ambient temperature is below +10 ºC or
above +40 ºC
Insert the battery pack
[ 2]
into the charger
[ 16]
.
Connect the power plug
[ 19]
to a suitable
electrical socket-outlet.
The charging control LEDs (green
[ 17]
and
red
[ 18]
) indicate the charging status of the
battery pack
[ 2]
.
LED Status
Red LED lights up
Battery pack is
charging
Green LED lights up
Battery pack is fully
charged
Green and red LED
flashing
Battery pack is
defective
Red LED flashing
Battery pack is too
cold or too warm
to be charged
Green LED lights up
(without battery pack) Charger is ready
When the battery pack is fully charged:
Disconnect the power plug
[ 19]
from the
electrical socket-outlet.
Remove the battery pack
[ 2]
from the
charger
[ 16]
.
m WARNING!
Always switch off and remove
battery pack
[ 2]
from the tool before
replacing accessory tools or adjusting
the tool.
˜
Connecting/removing the
dust extractor
m WARNING! FIRE HAZARD!
u
Using power tools with a dust extraction
element which can be connected to a
vacuum cleaner poses a fire hazard!
Unfavourable conditions, e.g. sparking,
sanding metal or metal pieces in wood,
wood dust inside the vacuum bag can
ignite. This can particularly occur if the
wood dust is mixed with paint particles or
other chemicals and the ground product
is hot after long work periods. Therefore
avoid the sanding material and the
product overheating. Always empty the
vacuum bag in the vacuum cleaner before
taking breaks.
u
Always use a dust extractor.
u
Ensure the work area is well ventilated.
u
Observe your country’s applicable rules
for the materials you are working on.
NOTE
u
Connecting or removing the dust extractor
[ 13]
: Use a a cross-head hand screwdriver
(not included).
(Fig. F)
Connecting the dust extractor
Place the dust extractor
[ 13]
at the bottom
side of the product.