Parkside PAAS 20-Li A1, Перевод оригинальной инструкции

Страница: 28 / 274

28
GB MT
p) Disconnect the power supply (e.g. pull
the plug out of the power outlet or re-
move the battery):
- when leaving the machine,
- before removing a blockage,
- before checking, cleaning or work-
ing on the machine,
- after hitting a foreign object to check
the machine for damage,
- if the machine begins to vibrate ab-
normally, check immediately.
Residual risks
There will always be residual risks even
if you operate this power tool according
to the instructions. The following hazards
may occur in connection with the type and
design of this power tool:
a) Cutting injuries
b) Health injuries resulting from the effect
of hand/arm vibration in the event that
the device is used over a longer period
of time or is not used and maintained
properly.
Warning! During operation, this
power tool produces an electromag-
netic fi eld. Under certain circumstances,
this fi eld may negatively affect active or
passive medical implants. In order to re-
duce the danger of serious or fatal injuries,
we recommend that individuals who wear
medical implants should consult their doc-
tor and the manufacturer of the implant be-
fore operating the machine.
Observe the safety informa-
tion and notes on charging
and proper use as shown in the in-
struction manual for your battery
and charger of the X 20 V Team se-
ries from Parkside. A detailed de-
scription of the charging process
and further information can be
found in the separate operating in-
structions.
Operation
Do not use the device without
safety goggles.
Prior to each use, ensure that the
machine is working correctly. Risk
of injury and damage to property.
Checking the charge
status of the battery
The battery charge status indicator (15)
shows the charge status of the battery (17).
The charge level of the battery (17) is indi-
cated by the corresponding LED light light-
ing up when you press the soft key (18).
Red-amber-green => battery fully charged
Red-amber => battery approx. half
charged
Red => battery needs to be charged
Charging the battery
Charge the battery (17) when only
the red LED of the charge level indi-
cator (15) is still lit.
1. Remove the battery (17) from the de-
vice.
2. Slide the battery (17) into the charging
slot of the charger (14).
3. Plug the charger into an outlet.
4. After charging is complete, a green
light will be illuminated permanently.
You can now disconnect the charger
from the mains supply.
5. Remove the battery (17) from the
charger.