22 GB/IE
The fuse of the car charger adaptor
[
12]
can
be exchanged .
The technical data of the fuse must comply
with information given in the section
“Technical data” . The fuse may only be
replaced by a qualified electrician .
CAUTION!
Do not connect the product to your
car‘s 12 V connection if the car battery is already
old and worn . Doing so could mean that the car
engine will no longer start .
NOTES:
In order to use the product without a
USB cable
[
13]
, you need to recharge the
rechargeable battery before use . The
charging process takes about 3 .5 hours . The
rechargeable battery is firmly integrated into
the base of the product .
Fully charge the rechargeable battery prior
to first use .
Charge the battery if it becomes empty
(only 1 LED of the charging indicator
[
6]
is
flashing) .
Open the protective cap
[
8]
.
Connect the USB cable
[
13]
with the
USB connector of the power adaptor
[
11]
or
the car charger adaptor
[
12]
.
Connect the USB plug (type C) of the
USB cable
[
13]
to the USB input socket
(type C)
[
9]
on the product .
Plug the power adaptor
[
11]
into a socket,
or plug the car charger adaptor
[
12]
into the
12 V socket in your vehicle .
NOTES:
The battery charging status is shown by the
charging indicator
[
6]
:
Charging indicator
[
6]
status
Battery
charging
status
1 LED flashes
0‒25 %
1 LED lights up, 1 LED flashes
25‒50 %
2 LEDs light up, 1 LED flashes
50‒75 %
3 LEDs light up, 1 LED flashes 75‒100 %
4 LEDs light up
100 %
The charging time is approximately 3 .5 hours
when the battery was drained .
NOTE:
The product has an overcharging
protection system . Nevertheless, you should
disconnect the product from the mains once the
charging process is complete .
Disconnect the USB cable
[
13]
from the
product to prevent the batteries discharging
themselves .
Close the protective cap
[
8]
before you start
to use the product again . Otherwise water
could enter to the product when it is used
outdoors .
Checking the battery capacity
When product is not charged: Press the battery
status button
[
7]
to check the battery capacity .
The green charging indicator
[
6]
shows the
capacity* of the battery inside the product .
1 LED lights up = 25 %*
2 LEDs light up = 50 %*
3 LEDs light up = 75 %*
4 LEDs light up = 100 %*
* This is the approximate percentage of battery
capacity but not actual measurement .
