Parkside 384506 2107, Оригинальное руководство пользователя

Страница: 14 / 197

PWS 230 D4 ■ 10 │
GB
│
IE
Use
Mounting/adjusting the blade guard
WARNING! RISK OF INJURY!
► Always remove the plug from the power
socket before working on the appliance.
RISK OF INJURY!
► Always use the angle grinder with the blade
guard . The blade guard should be fitted
securely. Set it so that the highest possible
degree of safety is achieved, i.e. the smallest
possible part of the grinding disc is open to
the operator. The blade guard is designed
to protect the operator from fragments and
accidental contact with the grinding tool.
► Make sure that the blade guard is fitted
at least at the same angle as the additional
handle
(see fig. B). Otherwise, you could
cut injure yourself on the roughing disc or
cutting disc.
♦ Put the protective cover in the position shown
(see Fig. F). The protective cover can only be
put on or removed in this position. Turn the
protective cover until it clicks into place for the
first time.
♦ Now pull the lever and turn the protective
cover into the required position (working
position) until it clicks into place.
♦ Check the secure seat of the protective
cover. The lever must be engaged and the
guard must not twist.
Fitting the additional handle
CAUTION!
► For safety reasons, this appliance may only
be used with the additional handle .
Failure to do this can lead to serious injury.
The additional handle can be screwed
onto the left or the right depending on the job
at hand.
Fitting/changing the roughing/
cutting disc
Always wear protective gloves when changing
cutting/rough grinding discs.
Roughing and
cutting discs become very hot. Allow them to cool
down completely before touching them.
Pay attention to the dimensions of the roughing/
cutting disc. The diameter of the hole must fit the
mounting flange without any play. Do not use a
reducer or adapter.
■ Check the roughing/cutting disc. It should
not be damaged or damp, and it should have
no cracks.
Otherwise, it could break during use
and cause injuries.
NOTE
► Use only discs which are free of dirt.
■ Use only grinding discs whose permissible
speed rating is at least as high as that on the
type plate on the power tool.
■ RISK OF INJURY! Press the spindle locking
button only when the mounting spindle
is at a complete standstill.
♦ Press the spindle locking button to lock the
spindle.
♦ Undo the clamping nut using the two-hole
mounting spanner (see fig D).
♦ Place the rough grinding or cutting disc with
the label side towards the appliance on the
mounting flange .
♦ Fitting the cutting disc:
Then replace the clamping nut on the attach-
ment spindle with the raised side facing up.
Fitting the roughing disc:
Then replace the clamping nut on the attach-
ment spindle with the raised side facing
down.