Parkside 337008 2001, Перевод оригинальной инструкции

Страница: 8 / 40

PGS 500 A1 GB
│
IE
│
NI
│
CY
│
5 ■
5. Service
a)
Have your power tool serviced by a qualified
repair person using only identical replace-
ment parts.
This will ensure that the safety of
the power tool is maintained.
WARNING!
Always wear safety googles
Wear a dust mask.
Safety instructions for all
applications
General safety instructions for grinding,
working with wire brushes, polishing and
milling
a) This power tool is intended for use as a
grinder, sandpaper sander, wire brush, pol-
isher, milling machine and abrasive cutting
appliance. Please follow all safety instructions,
instructions, diagrams and data that you re-
ceive with the appliance.
If you do not observe
the following instructions, this can lead to an
electrical shock, fire and/or serious injuries.
b) This power tool is not suitable for sandpaper
sanding or abrasive cutting. Using the power
tool for applications for which it is not desig-
ned is hazardous and may cause injuries.
c) Do not use any accessories that have not
been provided or recommended for this
power tool by the manufacturer.
Just because
you can attach the accessories to your power
tool, does not guarantee safe use.
d) The permissible speed of the attachment part
must be at least as high as the maximum
speed specified for the power tool.
Acces-
sories that rotate faster than the permissible rate
can break and throw pieces into the air.
e) The external diameter and thickness of the
attachment part used must comply with the
dimensions of the power tool.
Incorrectly
dimensioned attachment parts cannot be suf-
ficiently shielded or controlled.
f) Grinding discs, sanding drums or other ac-
cessories must match exactly the grinding
spindle or collet chuck of your power tool.
At-
tachment parts that do not fit precisely into the
take-up of the power tool will rotate unevenly, vi-
brate severely and can lead to a loss of control.
g) Discs, grinding cylinders, cutting tools or
other accessories mounted on a mandrel must
be inserted completely in the collet or chuck.
Any "protrusion" or exposed parts of the
mandrel between the grinding tool and the
collet or chuck must be kept to a minimum.
If
the mandrel is not sufficiently tightened or the
grinding tool protrudes too far, the attachment
part can come loose and be ejected at high
speed.
h) Never use damaged attachment parts. Before
each use, check attachment parts such as
grinding discs for chips or cracks, sanding
drums for cracks, deterioration or excessive
wear and tear, and wire brushes for loose
or broken wires. If the power tool or the at-
tachment part is dropped, check to see if it is
damaged or use an undamaged attachment
part. When you have checked and inserted the
attachment part, ensure that you and any other
people nearby remain outside of the range of
the rotating attachment part and allow the tool
to rotate at maximum speed for one minute.
Damaged attachment parts usually break during
this test period.
i) Wear personal protective equipment. Depend-
ing on the application, ensure that you use
full face protection, eye protection or safety
goggles. If appropriate, use a dust mask, ear
protectors, protective gloves or special apron
to protect you from grindings and material
particles.
The eyes should be protected from
flying debris that may be caused during certain
applications. Dust or filter masks must be used to
filter any dust created by the application. If you
are exposed to loud noise for a longer period,
you may suffer hearing loss.