Parkside 336350 1910, Инструкции по эксплуатации и безопасности

Страница: 14 / 47

14 GB/IE
protective gloves at all times if such an event
occurs.
This product has a built-in rechargeable battery
which cannot be replaced by the user. The
removal or replacement of the rechargeable
battery may only be carried out by the manu-
facturer or his customer service or by a similarly
qualified person in order to avoid hazards. When
disposing of the product, it should be noted that
this product contains a rechargeable battery.
Before use
Charging the product
Note: Remove all packaging materials from the
product.
Note: In order to use the product without a USB
cable
6
, you need to recharge the rechargeable
battery before use. The charging process takes about
7 hours. The rechargeable battery is firmly integrated
into the base of the product.
Note: This product may only be charged by using
the USB cable
6
provided with the specified input
voltage and current (see “Technical data”).
Connect the USB cable
6
with the charging
device.
Connect the USB (type C) connector on the
USB cable
6
to the USB (type C) input socket
7
on the product (see Fig. C).
Note: During charging, the charging indicator
8
lights up red. When charging is complete, the charging
indicator
8
lights up green. When the charging
indicator
8
is green, pull the USB cable
6
from
the product to prevent the battery from discharging.
Use
You can use the product in the following
ways:
- Use the product by holding the grip
3
at both
side of the strip light
1
.
- You can secure the product by using either one
or two hook
4
which is located at the base in
both sides. If using two hooks, hold the joint
5
and tilt up the grip
3
so it is perpendicular to
the strip light
1
. Then take out the hooks
4
and hang it on desired place (see Fig. B).
- You can use the product by securing it to a
flat, ferromagnetic surface using the magnetic
base
9
.
CAUTION! If you want to attach the product
to a surface in horizontal position, ensure the
magnet at both side were attached to the ferro-
magnetic surface (see Fig. E). Otherwise the
strip light
1
may fall down due to its weight.
You can adjust the lighting angle by rotating
the strip light
1
with your hand.
- You can attach the product on the provided tri-
pod
10
and make the product stand on desired
location (see Fig. D).
CAUTION! Make sure the grip
3
with ON /
OFF switch
2
is attached to the tripod
10
. Do
not tilt the strip light
1
more than 90 °, other-
wise the product may overturn.
CAUTION! Please note the position of your
hands whilst turning the grip
3
to prevent
pinching your fingers (see Fig. F).
Using the product
Fully charge the product as described in the
section “Charging the product“.
Press the ON / OFF switch
2
repeatedly to
switch the product into different modes.
Press 1x: Light up at one side
Press 2x: Light up at both side
Press 3x: Switch off the light
Maintenance and cleaning
The product requires no maintenance. The LEDs
cannot be replaced.
Switch off the product and disconnect from the
USB cable
6
before cleaning.
Never immerse the product in water or other
liquids.