Parkside 322689 1901, Инструкции по эксплуатации и безопасности

Страница: 42 / 174

41 GB/IE
Additional safety instructions for wire
brushing operations – Safety warnings
specific for wire brushing operations
1)
Be aware that wire bristles are
thrown by the brush even during
ordinary operation. Do not
overstress the wires by applying
excessive load to the brush.
The wire
bristles can easily penetrate light clothing
and/or skin .
2)
If the use of a guard is
recommended for wire brushing,
do not allow any interference of
the wire wheel or brush with the
guard.
Wire wheel or brush may expand
in diameter due to work load and centrifugal
forces .
Additional angle grinder warnings
1) Only use grinding wheels where the
indicated rotational speed is at least as high
as what has been specified on the name
plate of the product .
2) Carry out a visual inspection of the grinding
wheel before use . Do not use any damaged
or deformed wheels . Replace any damaged
or worn wheels .
3) Make sure that the sparks produced by
grinding do not present a danger, e .g . reach
people or ignite flammable substances .
4) Always wear safety goggles, safety gloves,
respiratory protection and ear protection
when grinding .
5) Never keep the fingers between the wheel
and spark protection or in close proximity
to the protective hoods . There is a risk of
crushing .
6) The rotating parts of the product cannot be
covered due to functional reasons . Therefore,
proceed cautiously and hold the workpiece
firmly in order to avoid slipping which could
cause your hands to come into contact with
the wheel .
7) The workpiece gets hot during grinding . Do
not touch the machined area, allow it to cool
down . There is a risk of burning . Do not use
coolants or the like .
8) Do not work with the product, if you are tired
or have consumed alcohol or tablets . Always
have a break on time .
9) Turn off the product and, before doing any
servicing, remove the battery pack .
˜
Vibration and noise reduction
To reduce the impact of noise and vibration
emission, limit the time of operation, use low-
vibration and low-noise operating modes as well
as wear personal protective equipment .
Take the following points into account to minimise
the vibration and noise exposure risks:
¾
Only use the product as intended by its
design and these instructions .
¾
Ensure that the product is in good condition
and well maintained .