Parkside 317725, Перевод оригинальной инструкции

Страница: 8 / 24

PDSSE 550 A1
GB
│ 5 ■
h) Keep handles and grasping surfaces dry,
clean and free from oil and grease.
Slippery
handles and grasping surfaces do not allow
for safe handling and control of the tool in unex-
pected situations .
5 . Service
a) Have your power tool serviced by a qualified
repair person using only identical replace-
ment parts.
This will ensure that the safety of
the power tool is maintained .
Appliance-specific safety instructions
for impact wrenches
■ Wear hearing protection when impact screw-
ing.
Exposure to loud noise can lead to hearing
loss .
■ Secure the workpiece. A workpiece securely
held by a clamping device or vice is much safer
than one held in your hand .
■ Hold the power tool firmly. High torques can
occur for brief periods while tightening and
loosening screws .
■ Wait until the power tool has come to a
standstill before putting it down.
The tool
could catch in something and thus lead to loss
of control of the power tool .
■ Hold the power tool by insulated gripping sur-
faces, when performing an operation where
the fastener may contact hidden wiring.
Fasten-
ers contacting a “live” wire may make exposed
metal parts of the power tool “live” and could
give the operator an electric shock .
WARNING!
■ To avoid potential risks, damaged mains
cables should be replaced by the manufac-
turer, their customer service department or a
similarly qualified person .
ATTENTION!
Hot surface .
There is a risk of burns .
Setting up
WARNING!
► Switch the appliance off and remove the
power plug before starting any work on
the appliance .
Switching on and off
Switching on:
♦ Press the ON/OFF switch to start the appli-
ance .
The appliance starts at maximum speed .
■ The tightening torque depends on the impact
duration .
Switching off:
♦ Release the ON/OFF switch to switch off the
appliance .
ATTENTION!
♦ The tightening torque actually attained must
always be checked with a torque wrench!
Changing the direction of rotation
WARNING!
► The rotation direction switch may only be
used/adjusted when the appliance is at a
standstill .
♦ Change the direction of rotation by pressing
the rotation direction switch towards the left
or right .
NOTE
► In clockwise rotation, the maximum torque is
limited to 100 Nm .
Fitting a socket
♦ Push one of the supplied sockets onto the
tool holder .