Parkside 290849, Инструкция по эксплуатации

Страница: 35 / 136

PWSA 20-Li B2 ■ 30
│
GB
│
IE
■ Always remove the battery during work
breaks, when servicing the appliance and
when it is no longer in use.
The appliance must
be kept clean, dry and free of oil and grease at
all times.
■ Remain alert at all times! Always pay attention
to what you are doing and act with common
sense.
Do not use the appliance if you are
distracted or feeling unwell.
WARNING!
Always wear safety goggles.
WARNING!
Always wear a dust mask!
Before use
Charging the battery pack (see fig. A)
CAUTION!
► Always unplug the appliance before you
remove the battery pack from or connect
the battery pack to the charger.
■ Never charge the battery pack when the
ambient temperature is below 10°C or above
40°C.
♦ Connect the battery pack to the high-speed
battery charger (see fig. A).
♦ Insert the power plug into the socket.
The control LED lights up red.
♦ The green charge control LED indicates that
the charging process is complete and the bat-
tery pack is ready.
ATTENTION!
♦ If the red charge control LED flashes, this
means that the battery pack has overheat-
ed and cannot be charged.
♦ If the red and green charge control LEDs
both flash, this means that the battery
pack is defective.
♦ Switch off the charger for at least 15 minutes
between successive charging sessions. Also
disconnect the power plug from the mains
power socket.
Attaching/disconnecting the battery
pack to/from the appliance
Attaching the battery pack:
♦ Push the battery pack into the handle until it
clicks into place.
Removing the battery pack:
♦ Press the release button and remove the
battery pack .
Checking the battery charge level
♦ Press the battery charge level button to
check the status of the battery (see also main
diagram).
The status/remaining charge will be shown on
the battery display LED as follows:
♦ RED/ORANGE/GREEN = maximum charge
RED/ORANGE = medium charge
RED = low charge – charge the battery
Fitting the blade guard with quick
release
WARNING! RISK OF INJURY
► Always switch the appliance off and remove
the battery before carrying out any work on
the appliance.
RISK OF INJURY
► Always use the angle grinder with the blade
guard . The blade guard should be fitted
securely. Set this so that the highest possible
degree of safety is achieved, i.e. the smallest
possible part of the grinding disc is open to
the operator. The blade guard is designed
to protect the operator from fragments and
accidental contact with the grinding tool.