Parkside 281995, Перевод оригинальной инструкции

Страница: 38 / 43

PSTDA 20-Li A1 ■ 34
│ GB
Fitting the splinter guard
The splinter guard can prevent the tearing up of
the surface when sawing wood. The splinter guard
can only be used with certain sawblade types
without the sliding shoe and only at a cutting
angle of 0°.
♦ Press the splinter guard into the footplate
from below (notch facing upwards).
Fitting the sliding shoe
When working on sensitive surfaces, you can fit
the sliding shoe on the baseplate to prevent
scratching the surface.
♦ Mount the sliding shoe onto the front of the
baseplate and press it up at the back until it
clicks into place on the baseplate .
♦ To remove the sliding shoe , unfasten it at
the rear of the baseplate and slide it off the
front.
Use
Setting the cutting angle
♦ Undo the clamping screws with the supplied
hex key and pull the baseplate to the rear.
♦ Adjust the cutting angle to 0°/15°/30°/45°
with the aid of the markings on the baseplate .
Push the baseplate forwards so that the
locking pin engages in the toothing .
♦ Retighten the clamping screws with the hex
key.
NOTE
► When using a cutting angle of 15°/30°/
45°, the blade guard and the splinter
guard must be detached beforehand.
Setting the stroke rate
The ON/OFF switch has a variable speed con-
trol. Press the ON/OFF switch lightly for a low
speed. Increasing the pressure increases the speed.
NOTE
► The integrated motor brake ensures rapid
stoppage.
Adjusting the pendulum stroke
♦ You can use the pendulum stroke switch
to adjust the pendulum movement of the saw
blade . You can achieve fine, clean-cut edges
without pendulum movement (setting "0").
Deactivate pendulum movement when working
on thin workpieces. You can achieve an increas-
ingly fast work rate if the pendulum stroke is
activated (settings 1–3).
Switching on/off
Switching the appliance on:
♦ Push the safety lock-out to the left or right
and keep it pressed.
♦ Press the ON/OFF switch .
Once the saw is running, you can release
the safety lock-out . The working light
illuminates when the ON/OFF switch is
depressed lightly or completely. This provides
illumination of the work area in poor lighting
conditions.
Switching the appliance off:
Release the ON/OFF switch .