20 GB
… / Disposal / Translation of the original declaration of conformity / Manufacturer
Bringing into use / Maintenance and cleaning / Service
5. Press the lever of the valve connector
5
down-
wards and pull the valve connector
5
off the
valve.
6. After you finish work, disconnect the device from
the compressor.
NOTE:
First disconnect the hose from the com-
pressor and only then disconnect the compressed
air supply hose from the device. This will ensure
that the compressed air supply hose does not
wave around in an uncontrolled manner.
Using accessories:
Press the lever of the valve connector
5
and
insert the desired accessory
10
to
13
or the cap
9
into the valve connector
5
(
Presta valve
(see Fig. F), e.g. cycle tyre valve; (
Dunlop
valve
(see Fig. G), traditional cycle tyre valve).
TIP:
Use the valve adapter
13
for the cycle tyre
valves shown.
Q
Using the blow gun
7
1. Screw an extension nozzle
8
on to the blow
gun
7
.
2. Press the trigger
6
to start the delivery of air.
3. Release the trigger
6
to stop the delivery of air.
4. After you finish work, disconnect the device
from the compressor.
NOTE:
First disconnect the hose from the com-
pressor and only then disconnect the compressed
air supply hose from the device. This will ensure
that the compressed air supply hose does not
wave around in an uncontrolled manner.
Q
Maintenance and cleaning
DANGER OF INJURY!
Always disconnect the device from the compressed
air source before you clean or maintain it.
The device requires no maintenance.
Do not use sharp objects for cleaning the device.
Do not allow any liquids to enter the device.
Otherwise the device could be damaged.
Clean the device frequently; for best results, do
this immediately after you have finished using it.
Clean the housing with a dry cloth.
Service
Should problems arise whilst operating your ROWI
Electronics product, please proceed as follows:
1. contact us
You may contact the ROWI Electronics Service
Team at:
ROWI Electronics GmbH
Augartenstr. 3
76698 Ubstadt-Weiher, Germany
[email protected]
Service hotline: +49 (0) 7253 9460-40
Most problems can be resolved with the skilled
technical support of our Service Team.
2. Should an inspection or repair by the
ROWI Electronics Service center be
required, please proceed as follows:
– Pack product
Pack the product in the original packaging.
Ensure it is adequately padded and protected
from impact. Transport damage is not covered
by the warranty.
– Include receipt
The sales receipt must be included. Repairs
under warranty can only be processed with
the sales receipt.
– Send product
Only send the product to the above address
after contacting the ROWI Electronics Service
Center.
Содержание 275674
Страница 3: ...B A 4 6 6 9 14 15 16 5 2 1 8 9 10 11 8 14 4 12 13 16 15 7 3...
Страница 4: ...C D E H F G...