Parkside 2249, Инструкции по эксплуатации и безопасности

Страница: 74 / 101

74 GB/MT
of the standard, arc welding
devices can still result in electro-
magnetic interferences in sensitive
systems and devices. The operator
is responsible for malfunctions
that occur through the arc while
welding and must take suitable
protective measures. In doing so,
the operator must consider the
following:
– network, control, signal and
telecommunication lines
– computers and other micro-
processor-controlled devices
– TVs, radios and other playback
devices
– electronic and electrical safety
equipment
– people with cardiac pace-
makers or hearing aids
– measurement and calibration
devices
– interference immunity of other
equipment nearby
– the time at which the welding
work is carried out.
The following is recommended
to reduce possible interference
radiation:
– equip the mains connection
with a mains filter
– the welding device must be
regularly maintained and kept
in a good condition
– welding cables should be
completely uncoiled and run as
close to parallel with the floor
as possible
– devices and systems that are
compromised by the inter-
ference radiation must be
removed from the welding area
or shielded.
z
Before use
Take the device and accessories out
of the packaging and check them for
damage (e.g. transport damage).
„
Fix the carrying strap
1
onto the
device (see Fig. C1–C4).
„
Connect the electrode holder
5
and
the earth terminal
4
to the welding
device.
„
Position an electrode in the clamps
of the electrode holder.
z
Fit welding mask
„
Fit the handle
8
onto the welding
mask
7
, as shown in Fig. A.
„
Fit the protective glass
11
on to the
welding mask
7
, as shown in
Fig. A.
„
The protective glass
10
must be
pushed in from the top.
Note: If you are not able to push the
protective glass
10
in fully, gently press
on the outside of the protective glass
10
.
z
Using the device
Note: The welding device is designed
for welding with electrodes.
„
Use the electrode holder clamps
without protruding bracket screws,
which meet the current safety
standards.
Safety instructions / Before use / Fit welding mask / Using the device