Parklander MT125 Series, Руководство оператора

Страница: 25 / 32

25
en
TROUBLESHOOTING
PROBLEM LOOK FOR REMEDY
Engine will not turnover or
start.
Brake pedal not depressed. Fully depress brake pedal.
PTO (electric clutch) switch
is in ON position.
Place in OFF position.
Cruise control engaged. Move knob to NEUTRAL/OFF position.
Out of fuel. If engine is hot, allow it to cool, then refill the fuel tank.
Engine flooded. Disengage the choke.
Fuse is blown. See authorized dealer.
Battery terminals require
cleaning.
See Cleaning the Battery and Cables section.
Battery discharged or dead. Recharge or replace battery.
Wiring loose or broken. Visually check wiring. If wires are frayed or broken, see authorized dealer.
Solenoid or starter motor
faulty.
See authorized dealer.
Safety interlock switch
faulty.
See authorized dealer.
Water in fuel. See authorized dealer.
Gas is old or stale. See authorized dealer.
Engine starts hard or runs
poorly.
Fuel mixture too rich. Clean air filter.
Engine has other problem. See authorized dealer.
Engine knocks.
Low oil level. Check/add oil as required.
Using wrong grade oil. See Oil Recommendations section.
Excessive oil consumption.
Engine running too hot. See authorized dealer.
Using wrong grade oil. See Oil Recommendations section.
Too much oil in crankcase. Drain excess oil.
Engine exhaust is black.
Dirty air filter. Replace air filter.
Choke closed. Open choke.
Engine runs, but tractor will
not drive.
Ground speed control pedals
not depressed.
Depress pedals.
Transmission release lever
in PUSH position.
Move into DRIVE position.
Parking brake is engaged. Disengage parking brake.
Traction drive belt is broken
or slipping.
See authorized dealer.
Troubleshooting the Tractor
Not
for
Reproduction