9
3
Turn the Ball Mount Counter
Clockwise
until the gap
between the Ball Mount Collar
and Trailer Tongue closes.
The top edge of the Ball Mount
and the Trailer Tongue should
be
flush, with no gap
.
The connection should be tight
without any ball pivot.
NOTE: THRUST WASHER
Gap in your connection?
Have a Step Down or another
obstruction in the way?
You may need a
Thrust Washer
.
Find
Thrust Washer
Installation
instructions on Page
10
.
4
Once the connection is secure,
use the
Tightening Bar
to
ensure that the connection is
as tight as possible.
This may take a few rotations.
5
With the Force Dolly in
Freewheel Mode
, move the
dolly underneath the hitch.
Using the Trailer Jack, lower
the Ball Mount into the Dolly’s
Receiver Tube until the bottom
edge is no longer visible.
6
Using the Motor Knob, switch to
Engaged Mode
. Move the Dolly
in
Reverse
to level it out.
Continue lowering the trailer
onto the Dolly to fully insert the
Ball Mount.
Lift the trailer jack all the way
up, and you’re ready to go!
P A R K I T 3 6 0 ° / F O R C E 5 K & 1 0 K M A N U A L
PROPER CONNECTION:
FLUSH, FLAT, NO GAP
READY TO GO!
