7. OPERATION
Programming of the telephone numbers in and whenever the
unit
receives a call will recognize an
authorized telephone number calling it and will then reject the call without answering (so there will
be no charge) and open the gate or
door. The relay can also be temporarily or permanently switched
on or off by sending SMS or dialing in.
This GSM Opener can allow user to gain access from their mobile phone by two methods
1. Caller ID recognition
2. by access control password
mode
1. Caller ID recognition to open
Ring in to open the door for authorized telephone number.
2. Access control password to open
Dial the SIM card telephone
number. The unit will answer the call and you will hear a bleep tone.
The door can be opened after enter correct pass code.
To trigger door by pressing *71*5678#
To latch or hold door by pressing * 72*5678#
To unlatch door by pressing * 73*5678#
* Above operation same as sending SMS commands
*This is for door open option for telephone numbers not stored.
8.Programming
Programming can be carried out either by text message or by dailing into the GSM door opener.
8.1 Progrmming by dialing
in
Dial the SIM card telephone number. The unit will answer the call and you will hear a bleep tone.
Enter Programming Mode by Pressing
…..
*12*
1234
# (1234 is default password)
A successful pass code will produce a single long beep. A failed attempt will produce 3 short bleeps.
Example: start to program the phone number for dialing in to open the door.
Use the following commands to program the unit
* Insert international country code (1~3 digits):
71 [country code]
#
* Add a number (up to 100 numbers):
721 [phone number] #
* Delete a number:
73 [phone number] #
* Delete all numbers:
73*#
Please note you must see Page 11 Step 9 to authorise
a telephone number to make programming changes first!
Page 9
