Parking Facilities PF6000, Руководство по эксплуатации и обслуживанию

Страница: 2 / 24

Address: Tel: Email: Web:
Safety Features
Thank you for purchasing one of our perimeter security products.
Your barrier will provide safe and reliable service and peace of mind provided that the following
instructions and guidance is followed.
Your barrier is fitted with a range of safety devices designed to prevent accidents or injury, none the
less the area in the immediate vicinity of the barrier should be treated as potentially hazardous and
avoided whenever the barrier is moving (shown below).
Explanation of safety features and barrier reaction:
Dual Height Photocells – (either side of moving barrier leaf) stops barrier closing and
reverses to the fully open position. (IF FITTED)
CAT 3 Safety Edges – Safety edges are direction dependant and will stop barrier and reverse
in the opposite direction to which the barrier was moving. (FITTED ON PLAIN POLE ARMS)
Emergency Stop Button – located on the front of the barrier cabinet this can be used before
an incident happens (IF FITTED)
Please Note:
Inductive safety edges are fitted as standard to meet the force limitation as required and
specified in BS EN12978:2000, unfortunately this cannot be achieved when under lattice or
security hi-bar lattice is installed / retro-fitted to the barrier beam. It is the responsibility of
the installer to carry out the necessary risk assessment and install the appropriate safety
devices to make the barrier meet the current standards such as light curtains, laser safety
sensors or photo electric cells.
Safe use warnings:
1. Do not allow children/people with physical or mental impairment to play on or near the
barrier. Barriers are
designed for vehicular use only
2. Keep remote control devices away from children.
3. Do not try to pass through/over/under the moving barrier.
4. Do not stop unnecessarily when passing through the barrier.
5. Only operate the barrier controls when in view of the barrier.
6. Do not attempt to interfere or modify the barrier from the factory setup.
7. Make sure the barrier is maintained by a trained and qualified powered barrier specialist at
the prescribed 6 monthly intervals and that services are recorded in this manual’s log.
8. If any sign of malfunction occurs switch off the barrier, manually release it and contact a
trained and qualified powered barrier specialist immediately.