Parker SMOKEETER SE-40, Руководство пользователя

Страница: 9 / 32

5
Owner's Manual:
SMOKEETER® Electronic Air Cleaner
4.2 Suspension
Threaded rod, wire or eyebolts and chain may be used
for hanging the unit. Four “knockouts”, located as shown
in Figure 4, must be removed.
It is recommended that a nut on the inside and outside
of the cabinet be used to lock the fastener in place.
Refer to Figure 4.
Test the unit for secure support.
FIGURE 4
5.0 OPERATION
5.0 OPERATION
For best results and to assure maximum air quality,
your SMOKEEETER unit should be started before the
air becomes contaminated. An indicator lamp indicates
that high voltage to the components is on. A variable
or multispeed control switch allows you to adjust the
blower speed. If you notice a decrease of cleaning
efficiency, increase the blower speed to increase
effectiveness of the unit.
FOR YOUR INFORMATION
— The equipment has been
thoroughly tested prior to shipment from the factory.
Even so, there may be some initial arcing of the
components at start-up. The noise should cease
after a few minutes of operation.
6.0 CLEANING
C A U T I O N
SERVICING THIS PRODUCT FOR PURPOSES OTHER THAN
ROUTINE CLEANING OF THE COLLECTION COMPONENTS
SHOULD BE PERFORMED BY TRAINED AUTHORIZED
SERVICE PERSONNEL. ANY EFFORT TO EXCEED THIS
SERVICE (BY NON-QUALIFIED PERSONNEL) MAY LEAD TO
BODILY INJURY AND/OR EQUIPMENT FAILURE.
This section is defined for cleaning and periodic mainte-
nance. The internal components must be removed prior
to cleaning.
C A U T I O N
THE UNIT SHOULD BE INSPECTED FREQUENTLY AND DIRT
REMOVED TO PREVENT EXCESSIVE ACCUMULATION
WHICH MAY RESULT IN FLASHOVER OR FIRE DAMAGE. AN
ELECTRICAL INTERLOCK IS PROVIDED FOR PROTECTION
— DO NOT DEFEAT ITS PURPOSE.
6.1 How to Remove Components
1. Turn off the unit.
• Open the access door.
• For added safety, manually discharge the ionizer and
collection cell/unicell in the following manner. Place the
blade of a common screwdriver (with insulated handle)
across the ionizer wire support and then the ionizer
frame. Next, place the screwdriver blade across the
cell end plate and then across a cell “hot” plate. This
will remove any residual charge that may not have
bled off. Refer to figure 5.