Parker SMOKEETER SE-40, Руководство пользователя

Страница: 7 / 32

3
Owner's Manual:
SMOKEETER® Electronic Air Cleaner
1.0 IMPORTANT NOTICE
This manual contains important safety information and
precautionary measures. Read this manual thoroughly
and comply with the instructions given. It is impossible
to list all potential hazards associated with every dust
collection system in each application. Proper use of
the equipment must be discussed with Parker Hannifin
or your local representative. Operating personnel must
be aware of, and adhere to, the most stringent safety
procedures.
2.0 INSPECTION OF EQUIPMENT
Upon receipt of your unit, check for any shipping
damage. A damaged carton indicates that the
equipment may have received rough handling
during shipping that may have caused possible
internal damage. Notify your delivery carrier and
enter a claim if any damage is found.
3.0 HOW YOUR AIR CLEANER OPERATES
The motor/blower assembly draws air through an
aluminum mesh filter which removes the larger particles
in the contaminated air. As the particles pass through
the ionizer section, they are given an intense positive
charge. These charged particles are then collected on
cell plates. The clean air is redistributed into the room
by adjustable outlet diffusers.
3.1 Components that Make it Work
PREFILTER
traps the larger particles and evenly
distributes the air across the ionizing section to
maximize efficiency.
IONIZER
is made up of fine tungsten wires supported
between metal plates. When high voltage is applied to
these parts, a “corona” field is generated which imparts
a high-voltage charge on particles that pass through it.
COLLECTION CELL is made up of a series of convoluted
metal plates. These plates act like a magnet and attract
the charged particles removing them from the air. The
plates are alternately charged positive and ground. The
positive plates repel the particles while the ground
plates attract them, yielding a very high efficiency.
NOTE: The SE 40 contains an ionizer and collection cell
as a one piece assembly known as a unicell.
SPEED CONTROL SWITCH
allows you to adjust the
airflow between 450 and 950 CFM on the SE 40. The
switch on the SE 50 allows you to select 3 of 5 motor
speed taps. The SE 50 is shipped from the factory with
the switch wired to the low, medium and high speed
motor taps. By repositioning the wire connectors at the
motor the medium-low or medium-high taps can be used
instead of the factory selected low, medium or high.
MOTOR/BLOWER produces air movement by a low
speed, dynamically-balanced, forward-curved blower.
The direct drive motor is thermally protected.
4.0 INSTALLATIONS
NOTE: This product has been designed specifically for
commercial applications, such as offices, night clubs,
bowling centers and bingo halls. Parker Hannifin
assumes no responsibility for those applications
unlike the aforementioned.
C A U T I O N
TO REDUCE THE RISK OF ELECTRIC SHOCK, THIS
EQUIPMENT HAS A GROUNDING-TYPE PLUG THAT HAS A
THIRD (GROUNDING) PIN. THIS PLUG WILL ONLY FIT INTO A
GROUNDING-TYPE POWER OUTLET. IF THE PLUG DOES
NOT FIT INTO THE OUTLET, CONTACT QUALIFIED
PERSONNEL TO INSTALL THE PROPER OUTLET. DO NOT
ALTER THE PLUG IN ANY WAY.
SMOKEETER is designed to draw the contaminated air
through the unit and exhaust clean air back into the
room. The clean air is used to push contaminated air
around the room to the inlet of the unit. Directions of
air patterns and proper placement of the unit should
be established by your local SMOKEETER distributor
or by Parker Hannifin.
The unit can be installed by mounting on a wall or
suspending from the ceiling joists/structure.