Set-up
LCB Compact Linear Actuator
14
192-510014 N04 March 2010
2.2.4.
Attachment of Motor or Gearbox
If you ordered the LCB together with a coupling kit, the coupling housing with the
half-coupling is already mounted on the drive shaft of the linear actuator. In this
case please proceed with step 2, if not start with step 1.
(1) If the coupling housing and the half-coupling are not pre-assembled,
please proceed as follows:
Place half-coupling for small shaft diameter on the drive shaft (with distance AL to
LCB) and tighten clamping screw with torque MA.
Insert plastic part.
Mount coupling housing
(2) Coupling housing and half coupling are pre-assembled:
Place the other half-coupling on the gear- or motor shaft and fix with distance AK
to the flange surface of the drive unit with torque MA.
Fix gearbox and motor to the coupling housing (the gearbox shaft must be exactly
centrical with respect to the drive shaft of the linear actuator!
There should be only an air gap of about 0.5 - 1 mm between the half-coupling on
the gearbox- or motor shaft and the other half-coupling.
AK
ca. 1
AL
(1)
Unit
LCB040
LCB060
Drive Options
L
(PTN060)
U
(SMH60)
N
(SY56)
M
(PTN080)
W
(SMH100)
P
(SY107)
AK
Distance between flange surface of
the coupling housing and the
coupling
mm
23
4.5
40
15
13.5
54
MA
Tightening torque of clamping
screws
Nm
1.4
10.5
AL
Distance between flange surface of
the coupling housing and the drive
station
mm
8
14
Dimensional drawings of drive options
(see page 27)
Drawing without
lateral cover
