18
LINK TechBox/TechCard Instruction Manual - HA470016 Issue 5
Step 3 – Create a
LINK
Project
In ConfigEd, create a new project by using the
Project/Manage
menu. Refer to the ConfigEd
instruction manual HA353792 for details.
Step 4 – Configure the TechCard
1.
In the selected project, open a default Techbox template by going to
File/New/LtechBx2
.
2.
Enter the address (in this case: 10) and the file name (in this case: SVL-10), when prompted.
3.
Insert an Ordinal Writer block from the pulldown menu
Block/Techbox/Ordinal Writer.
4.
Give it a name OR1 (happens automatically) and double-click on it.
5.
Under Tag Number, enter 592. Close the window.
6.
Similarly, insert the other blocks required and connect them together as shown in Figure 3, to
complete the configuration.
Step 5 – Configure the Touchscreen
1.
In the correct project, open a default Multi-Page L5392 LinkScreen template by going to
File::New::L5392MP
2.
Enter the address (in this case: 11) and the file name (in this case: 5392-11), when prompted.
3.
Insert the blocks required and connect them together as shown in Figure 4, to complete the
configuration.
4.
ANNC.1 is an annunciator block that will show fault messages, should they occur. These
legend messages need to be entered in ANNC.1. Decoding information may be found in the
“Specification Table: Tag Number Order/ Tag 6” in the drive instruction manual HA463617.
Refer to figure 5.
5.
The resulting touchscreen layout is shown below.
Drive Healthy
Reverse
Jog
Start
Stop
Speed Setpoint
Motor Load
Page 1
Fast Stop
Coast Stop
Start
Stop
Speed Feedback
Frequency
Page 2
Motor Volts
Figure 3
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
