401/402/403XE Series Product Manual
5
Parker Hannifin Corporation
EMN Automation
-
Parker
Irwin, Pennsylvania
Chapter 1
-
Introduction
Product Description
401XE Positioner
The 401XE is a linear positioning table, targeted for a blend of performance and value, of just under
1.2”
width which provides travel length up to 160mm. The recirculating linear bearings support up to
16kg normal load. It features a ballscrew drive of 2mm lead, and is available with several motor mount
and limit/home switch options.
402XE Positioner
The 402XE is a linear positioning table, targeted for a blend of performance and value, of approximate-
ly
2”
width which provides travel length up to 220mm. The recirculating linear bearings support up to
90kg normal load. It features a ballscrew drive of either 2mm or 5mm lead, and is available with sever-
al motor mount and limit/home switch options.
403XE Positioner
Similar to but larger than the 402XE, the 403XE is a linear positioning table of just under
3”
width
which provides travel length up to 655mm. The recirculating linear bearings support up to 160kg nor-
mal load. It also features a ballscrew drive of either 5mm or 10mm lead, and is available with several
motor mount and limit/home switch options.
Unpacking
Unpacking
Carefully remove the positioner from the shipping container and inspect the unit for any evidence of
shipping damage. Report any damage immediately to your local authorized distributor. Please save
the shipping container for damage inspection or future transportation.
Incorrect handling of the positioner may adversely affect the performance of the unit in its application.
Please observe the following guidelines for handling and mounting of your new positioner.
DO NOT allow the positioner to drop onto the mounting surface. Dropping the positioner can gener-
ate impact loads that may result in flat spots on bearing surfaces or misalignment of drive com-
ponents.
DO NOT drill holes into the positioner. Drilling holes into the positioner can generate particles and
machining forces that may effect the operation of the positioner. Parker will drill holes if neces-
sary; contact your local authorized distributor.
DO NOT subject the unit to impact loads such as hammering, riveting, etc. Impacts loads generated
by hammering or riveting may result in flat spots on bearing surfaces or misalignment of drive
components.
DO NOT lift the positioner by the cables. Lifting positioner by the cables may effect electrical con-
nections. The unit should be lifted by the base structure only.
DO NOT expose positioner to mist, spray or submersion in liquids.
DO NOT disassemble positioner. Unauthorized adjustments may alter the positioner
’
s specifications
and void the product warranty.
