METHOD #2
This method is for mounting to surfaces with a heavy or course textures or for
easy and frequent removals
.
1.
With the Mounting Template cut out, hold the Mounting Template on the
mounting wall and line up line “B” to the distance measurement and line up
line “C” to the height measurement. When both lines are lined up, with a
pencil, place a mark for each mounting hole as shown as “D” on the
Mounting Template. Repeat this procedure on the opposite mounting wall.
2.
Drill a 3/16” hole at each mounting hole mark. Insert a plastic anchor in
each hole.
3.
Screw the 1” #8 screws into the plastic anchors; leave a distance of 1/8”
from the top of the plastic anchor to the bottom of the screw head as
shown. (See Figure 4)
Figure 4
4.
Place the heads of the inserted mounting screws through the mounting
holes on the back of the Infrared Head Units and pull downward slightly to
seat the mounting screws.
