OPERATING YOUR T 3 continued
Preset Stations
Instead of tuning to find your favorite stations, you can save them as Presets and recall
them instantly from a memory bank of 1 - 30. Preset numbers appear at the lower left
side of the display as P1 – P30. You can save up to 30 FM stations and 30 AM stations.
You need the remote control to select the preset numbers for stations you want to save.
Saving Stations as Presets
Tune to the station you wish to save in preset memory by either Seek or Manual tuning.
Press the
Mem
button on the remote control or the
Memory
button on the front panel briefly.
MEMORY in the front panel display will flash and the small indicator at the right of the
panel will illuminate red to let you know that the memory is ready to accept a new preset
Press the desired buttons
P 1- P 9 & 0.
SAVED will appear in the display for two seconds confirming the station is now saved
as a preset.
Before you can tune another station and save it as a preset, you must press the
<
Seek
>
or the
<
Manual
>
button on the remote control or the
< Select >
button on the front
panel until
< SEEK >
or
< MANUAL >
is displayed.
Repeat steps 1-6 above to save additional stations as presets.
YOU SHOULD KNOW
For FM, the display shows 108 when you select a preset number that doesn’t have an FM station
saved to it. For AM, the display shows 1720 when you select a preset number that doesn’t have
an AM station saved to it. This enables you to distinguish between preset numbers that you’ve
already assigned and those that are available. You can reassign a preset number to a new station
by repeating the Saving Stations as Presets above.
After you press the
Memory
or
Mem
button you need to press a preset number button within 3
seconds while the memory bank remains open. If you press the
Memory
or
Mem
button but
don’t press a preset button, the existing preset station (if any) will remain unchanged.
For two digit presets, press the second preset number button within a few seconds. For
example, for preset 17, press
P 1
then
P 7
right after. For preset 30, press
P 3,
then
0
right after.
After you press the button to save a single digit preset, there will be a 2-3 second delay until it
is saved or recalled. You can eliminate this delay if you press
0
before you press the preset
number button. Example, for preset 6, first press
0
, then press
P 6.
You can’t save a station as a preset while the T 3 display shows < PRESET >. You must select
< MANUAL > or < SEEK > before saving the station.
Selecting Preset Stations
Now that your favorite stations are saved as presets, you can recall them on the front
panel or with the remote control. There are several ways to recall preset stations.
Selecting Individual Preset Stations from the Remote Control
Turn on the T 3 by pressing the
On-Off
button on the front panel or the
On
button on
the remote control.
Press the preset buttons on the remote control for the preset station you want to listen
to (
P 1, P 2,
etc.).
1
2
3
4
1
2
5
6
7
15
See
page 18 for T 3 Front Panel and Remote Control layout
Содержание Halo T 3
Страница 1: ...T 3 Amplifier Owner s Guide...
