CONNECTING THE AC POWER CORD TO THE T 3
AC Power Connections
We recommend that you plug your T 3 into the same AC wall outlet or power strip that
powers your other audio components, especially the preamplifier or system controller.
Having all the audio components on the same power circuit helps prevent hum.
What You’ll Need:
• An IEC 65 AC Cord (provided)
• An AC outlet or high quality AC power strip within reach of the AC cord
Before Connecting
Remove power to all the components in your audio system.
To Connect
Plug the female end of the AC cord to the AC receptacle on the rear of the T 3.
Plug the male end of the AC cord to an AC outlet or power strip.
AC Voltage Selection Switch
The T 3 can operate on either 110-120 Vac or 220-240 Vac operation. When you
purchased your T 3, its rear panel Voltage switch was already set for the proper
voltage in your area. Nevertheless, it’s wise to double-check it before plugging into an
AC outlet.
If you move to a location with a different line voltage, you can easily convert the T 3.
For 110-120 Vac Operation:
Remove the lock-out bracket with a phillips screwdriver.
Next, slide the switch toward the left until the groove on the switch lines up with
115/60Hz.
Replace lock-out bracket.
For 220-240 Vac Operation:
Remove the lock-out bracket with a phillips screwdriver.
Next, slide the switch toward the left until the groove on the switch lines up with
230V/50Hz.
Replace lock-out bracket.
If you’re unsure about the correct setting for your region, please consult your
Parasound dealer or a qualified service technician
10
1
2
1
2
Содержание Halo T 3
Страница 1: ...T 3 Amplifier Owner s Guide...
