Paramount Fitness Ultra UV2, Инструкция по замене

Страница: 5 / 8

5
Connect the color wires to the corresponding
color inputs in the ballast.
You will need to use some of the additional
wires included with the kit.
1. Remove the pre-wired single white wire (E)
from the left side of the terminal block.
2. Install the supplied double white wire (A)
to the terminal block. Tuck wires behind
terminal block.
4. Using one of the green ground wires (D),
connect it to the right ground post. Make
sure the flat washer is underneath the ring
terminal of the green wire.
5. Connect all the color wires to the
corresponding color inputs in the ballasts.
3. Remove the short black wire (C) from the
pressure switch. Install the supplied “Y”
connector (B) to the pressure switch, then
connect both supplied short black wires (C)
to the “Y” connector.
A E
B
C
F
D
D
C
SINGLE BALLAST WIRING
TWO BALLASTS WIRING