1
2
3
4
5
1
2
3
4
1
2
3
4
5
6
PARAJET ZENITH PARAMOTOR
OWNERS INSTRUCTION & SAFETY MANUAL :: V2.2 :: NOV 2014
Fitting the Stand
The Parajet Zenith paramotor stand
is supplied in three pieces, two stand
uprights and one crossbar.
Insert the end of the crossbar into
the crossbar mount located near the
base of each leg. Push the crossbar
until the button clip engages and
secures the bar in position.
Align each leg of the stand assembly
with the mounting apertures found
on the each side of the backplate,
making sure the crossbar is located
towards the front of the chassis.
Push each leg until the button clip
engages and secures the stand in
position.
Remove the retaining bolts from the
outer ring clamps located at the end
of each leg. Keep these bolts in a
safe place.
Align the detached outer ring
section with one of the outer ring
clamps, so that the netting channel
is orientated towards the front of
the paramotor.
Thread the ring section through
both outer ring clamps until the ring
section is centrally located.
2
Fitting the Fuel Tank
Align the quick-release fuel tank to
the bottom of the backplate with the
‘Parajet’ logo facing towards the
rear of the paramotor.
Slide the fuel tank upwards so that
the carry handle fits neatly between
the blackplate, making sure the
retaining pin mounting holes align
correctly at the bottom of the
chassis.
Push the quick-release retaining pin
into the mounting hole and rotate
the pin 90 degrees in a clockwise
direction to lock in position and
secure the tank to the chassis.
Connect the fuel line to the tank
using the push-fit connector located
on the top right of the fuel tank. To
release the fuel line, squeeze the
metal tabs and pull apart.
Fitting the Harness & ‘Swan
Neck’ Pivot Arms
The Parajet Zenith paramotor harness and
‘swan-neck’ pivot arms are supplied ready
assembled.
On the rear of the backplate, locate
the harness attachment slots. Each
slot is number both on the front and
back of the backplate.
Starting with slot 1, thread the
attachment strap through and loop
back through slot 2. Now thread the
strap through slot 3 and loop back
through slot 4.
Finally thread the strap through slot
5 where any excess strap material
should be safely pushed inside the
backplate.
Make sure the harness is located
tight against the backplate and that
the attachment straps are pulled as
tight as possible.
Next, locate the pivot arm hinge
blocks on the left and right sides
of the backplate. Push each safety
locking pin upwards and fully extend
the pivot arm retaining pins.
Insert each ‘swan-neck’ pivot arm
into the hinge blocks making sure
the mounting holes align correctly.
Push the pivot arm retaining pins
back into the hinge blocks.
