Paragon 9120, Руководство пользователя

Страница: 5 / 17

A539
INSTALLATION INSTRUCTIONS
Inspection of Shipment
Unpack your new fryer and thoroughly check for any damage that might have occurred during
transportation. If any damage is identified, please process claims with the transportation company. The
manufacturer’s warranty does not cover damage that occurs in transit, or damage caused by abuse, or
consequential damage made while operating the fryer as it is beyond our control. Please reference
warranty in back of manual.
Owners Manual
Please read and understand the owner’s manual and all other safety and operating instructions before
using this equipment. To obtain additional copies of the owner’s manual visit manufacturedfun.com,
email or call Paragon customer service at cs@manufacturedfun.com or USA 1-(800)-433-0333 or write
to Paragon International, Inc, 731 W 18
th
Street, Nevada, Iowa 50201.
Unpacking
This fryer is fully assembled and has been tested at the factory.
1. Remove all packaging and tape prior to operation.
2. Place the fryer in a protected location on a level service and on a sufficiently stable base or table.
Note: The base or table must be strong enough to support the fryer when full of oil.
3. Remove accessories from the unit.
4. For non-digital fryers, set the thermometer bracket on the rim of the tank in a convenient location,
where the dial thermometer can be inserted and monitored without reaching over the tank.
5. After setup, the unit should be cleaned prior to use (see Care and Cleaning section of this manual).
Electrical Requirements
The following power supply must be provided:
Models: 9120 and 9125 require the following power supply: 20 Amp 6-20 Receptacle, 60 Hz
Models: 9130 and 9135 require the following power supply: 20 Amp 6-20 Receptacle, 60 Hz
DANGER
The Fryer must be properly grounded to prevent electrical shock to personnel. Failure to do so could
result in serious injury, or death. DO NOT immerse any part of this equipment in water. DO NOT use
excessive water when cleaning. Keep cord and plug off the ground and away from moisture. Always
unplug the equipment before cleaning or servicing. Make sure all fryer switches are in the OFF
position before plugging the equipment into the receptacle.
A certified electrician must furnish sufficient power for proper fryer operation and install any supplied
receptacle. Paragon recommends that this fryer be on a dedicated and protected circuit. Failure to
wire properly will void the warranty and may result in damage to the fryer. It is
Paragon’s
recommendation that this fryer be plugged directly into a wall outlet. The use of extension cords is
not recommended due to safety concerns, and may cause sacrificed and/or reduced performance.
Ensure the cord is placed such that it will not be a tripping hazard which could result in injury from hot
oil, impact of the heavy equipment or injury fall.