Paradyne JetFusion 2100 Series, Руководство пользователя

Страница: 78 / 296

56 2 0 0 0 - A 2 - G B 2 3 - 0 0
3
Type
“4”
to enable or disable receipt of ESF loopback commands. (This
option is valid only when Framing Mode is set to ESF). The IAD saves the
changes and redisplays the Select Loopback Configuration menu.
4
Press Escape to return to the T1 Configuration menu and continue with
other configuration tasks.
Configure Transmit
and Receive Channels
To configure Transmit and Receive Channels, follow the steps below.
1
Type
“6”
on the T1 Configuration menu (Figure 4.12) to select Configure
Transmit Channels, or
“7”
to select Configure Receive Channels. The
IAD displays a message indicating the number of channels enabled, and
displays the Channel Configuration menu (Figure 4.15).
Figure 4.15 Channel Configuration Menu
Each option on this menu is described in detail below.
Enable or Disable All Channels
Type
“1”
to enable all channels, or type
“2”
to disable all channels. The
IAD makes the change and resets the interface. (The menu and reset messages
may conflict; press any key to refresh the menu.)
Select Individual Channels
1
Type
“3”
to enable or disable specific channels. If all channels are
disabled, this option enables specific channels. Conversely, if all channels
are enabled, this option disables specific channels.The IAD displays
prompts you to select Channel Enable/Disable.
2
For each channel, type the number and press Enter. When you have entered
all channels to enable or disable, press Enter. The IAD saves the
configuration and displays the T1 Configuration menu.
3
Continue with other configuration tasks.
Select Channel Range
To select Channel Range, perform the following steps:
1
Type
“4”
to enable a range of channels. The IAD displays the channel
status and prompts you to select a Channel Range and to type in the
Beginning Channel.