Paradyne COMSPHERE 3911, Инструкция по установке и эксплуатации

Страница: 196 / 280

COMSPHERE 3900 Series Modems
14-6 September 1998 3910-A2-GN32-40
Table 14-2
(2 of 10)
391x Series AT Commands
AT
Command
DCP LCD
Command
Sequence
Description
Dn (cont.) @ — Quiet answer. Wait for five seconds of silence after dialing
the number. If the silence is not detected, the modem
sends either a NO ANSWER result to the DTE.
! — Hook flash. This causes the modem to go on-hook for 0.5
seconds then return to off-hook.
; — Return to Command mode. Modem returns to Command
mode after dialing a number without disconnecting the call.
Space — Ignored by the dial string, can be included to enhance
readability.
– — Ignored by the dial string, can be included to enhance
readability.
( ) — Ignored by the dial string, can be included to enhance
readability.
DS=n Dial Stored Number. Dials the number stored in Location n (1–24). (To
store a telephone number, refer to the &Zn=x command.) Call Setup\Dial\
Dial Directory:
En Command Character Echo.
E0 Disables echo to the DTE.
E1 Enables echo to the DTE.
Configure\Edit\
DTE Dialer
Hn Hook Switch Control.
H0 Modem goes on-hook.
H1 Modem goes off-hook.
H0: Call Setup\
Disconnect or
Control\Remove
Make Busy
H1: Control\
Make Busy
I
n Identification.
I 0 Displays product code — 144.
I
1 Displays 3-digit firmware revision number.
I 2 Performs an EPROM check.
Status\Identity
Ln Speaker Volume.
L0 Selects low volume.
L1 Selects low volume.
L2 Selects medium volume.
L3 Selects high volume.
Control\Speaker
Configure\Edit\
Misc
Mn Speaker On/Off.
M0 Speaker always OFF.
M1 Speaker ON until carrier signal is detected.
M2 Speaker always ON.
Control\Speaker
Configure\Edit\
Misc