Paradyne COMSPHERE 3911, Инструкция по установке и эксплуатации

Страница: 128 / 280

COMSPHERE 3900 Series Modems
7-8 September 1998 3910-A2-GN32-40
Clone Remote in Point-to-Point Configurations
Before using Clone Remote in point-to-point configurations, perform the following:
•
Make sure the 391x Series modems have an established leased-line connection using
either V.33, V.32terbo, V.32bis, V.32, or V.29 modulation (refer to the Leased Line section
in Chapter 4) or a dial network connection using either V.32terbo, V.32bis or
V.32 modulation (refer to Dial Line in Chapter 5, DCP Configuration).
•
Make sure the remote modem’s Access From Remote configuration option is enabled
(refer to the Misc section in Chapter 5, DCP Configuration).
•
Make sure the password (Remote Access Password configuration option) is the same in
both the local and remote modems. (For an example of how to change the password, refer
to the Editing and Saving a Configuration Option section in Chapter 5, DCP
Configuration.)
After completing these checks, proceed to Implementing a Clone Remote Operation on
page 7-12, which follows the descriptions of multipoint cloning operations.
Clone Remote in Broadcast Configurations
A tributary modem configured for extended diagnostics (Diagnostic Connection configuration
option set to Modem(DC)) can perform two types of Remote Clone operations. It can clone the
upstream, VF connected, control modem (SC_Clone) or it can clone all the 391x modems
attached to its downstream Diagnostic Channel (DC_Broadcast).
F1
Choose DLL Type >
SC_Clone
F2 F3
From the Choose DLL Type screen, press the F1 key to select SC_Clone to request the transfer
of an exact copy of the tributary modem’s firmware to the VF connected control modem.
Proceed to the section titled Implementing a Clone Remote Operation, which follows the
descriptions of multipoint cloning operations.
Cloning DC Broadcast Remote
Before using Clone Remote in DC Broadcast configurations, make sure the tributary modem’s
active poll list contains all the network management addresses for the control modems that
receive the download (refer to Chapter 6, Poll List Branch), and ensure that the control modems
are responding properly to polls (refer to Chapter 9, Sub-Network Health and Status Branch).
F1
Choose DLL Type >
DC_Broadcast
F2 F3