11
UC300 Universal Converter
Using a CA38A/RJ31 Phone Jack (available from your local supplier)
A CA38A phone jack allows the user to disconnect the panel/UC300 in case of a system malfunction where the
system holds the land line off the hook. The user will then disconnect the panel/UC300 from the line to enable
its use by the user.
Figure 7 – Using a CA38A Device
3.4 Reset
Reset switch
Resetting the UC300 puts all of the default configurations back in place.
1. Press reset switch for 5 seconds or until both status LEDs flash fast.
2. Release switch.
3. Press it again within the next 2 seconds to confirm the action.
After the reset, an event will be stored in the event buffer, the module will automatically perform a warm reset.
Note:
Use a paper clip or other thin hard tool to insert through the reset hole to the PC board ~ 1 inside the
UC300 case.
Caution: Do not use any sharp objects like a pin or a needle as this may damage the PC
board or reset switch.
3.5 Restart
To restart the UC300 without affecting the configuration you have two options:
• unplug the power transformer from the outlet and reinsert the plug
• restart using BabyWare
