Initial Setup/Installation of Driver
Paradox Setup
RS232 Settings
Set PRT3 Module RS232 Settings
Straight-Thru Male -> Female cable
RS232 Settings -> 19200, 8, none, 1, none
Setup Paradox Via Keypad Programming:
Press and hold 0
Enter your installer code
Enter 953 for DGP-848 or 4003 for EVO(96,192)
Enter the required information
Once in section programming
o
Enter 016
o
In this section only these numbers should be on: 1, 3 and 4Press enter
o
Press Clear until out of paradox programming
Setup Paradox via Babyware Programming:
Right click on the PRT3 module and choose Properties
o
Select the Options Tab
o
Enable [016]/1 (Serial Port on/off)
o
Enable [016]/4 (Turn on Home Automation Protocol)
o
Set [016]/2/3 to 19200
o
Set [016]/5/6 to Ascii Protocol
Save Settings
Special Notes/Tips:
Make sure that the PRT3 module has all the correct Usernames, Zone Labels and area names
you need. The driver downloads these items automatically saving you the hassle of doing it on the
Control4!
Control4 Setup
Load driver into Project
Set number of zones in project
Set number of active partitions
Set Defaults for Partitions
Set number of Users in project
If using the internal email options
