Paradox Liberator 9000, Руководство по установке

Страница: 9 / 15

to switch (key will flash), followed by the key corresponding to the next zone output
you wish to switch. The receiver will automatically copy the serial number from one
zone output to the other and vice versa. Note that an assigned zone can be
switched with a zone that has not been assigned (empty).
In this mode the receiver will not receive any type of transmission.
Example: Transmitter A has been assigned zone 1 and transmitter B has been assigned
zone 4. You wish to switch transmitter A to zone 4 and transmitter B to zone 1. Set the
receiver in Switch Zone Assignment Mode by pressing
[
ENTER
] + Installer Code + [
MEM
]
+ [3] . The [
ENTER
] and [
MEM
] keys will flash. Then press the [1] key (key will flash)
followed by the [4] key. Both keys will illuminate to indicate that transmitter A is now
assigned to zone 4 and transmitter B is now assigned to zone 1.
4.4 View Transmitter Serial Numbers
[
ENTER
] + Installer Code + [
MEM
] + [4]
This mode displays the serial number of the selected transmitter one digit at a time
by illuminating and extinguishing the key corresponding to the digit. If the
transmitter has already been assigned, the key corresponding to its zone output will
flash after displaying the serial number. After entering this mode, the
[
ENTER
] and
[
MEM
] keys will flash. The keypad will display the zones that have already been
assigned by illuminating the corresponding key. Any unlit keys represent zone
outputs that have not been assigned a transmitter. To view the serial number of a
device that has been assigned, press one of the lit keys which correspond to an
assigned zone output. To view the serial number of a transmitter which hasn’t been
assigned press and release the transmitter’s tamper switch.
For example, serial number 135789 has been assigned to zone output 3. The
keypad will illuminate the [1] key, then the key will extinguish. This will continue for
each digit in the serial number [3], [5], [7], [8] and [9]. Then the [3] key will flash.
4.5 Erase Specific Zone
[
ENTER
] + Installer Code + [
MEM
] + [0]
An assigned zone can not be overwritten; you must first erase it in order to assign
a new transmitter to that zone. To clear a zone, enter the erase zone mode by
14
15
pressing [
ENTER
] + Installer Code + [
MEM
] + [10] . After entering this mode the
[
ENTER
] and [
MEM
] keys will flash and the keypad will display the zones that have
already been assigned, by illuminating the corresponding key. Any unlit keys
represent zones that have not been assigned. Press the key (must be lit)
corresponding to the zone you wish to erase. The key will extinguish to indicate the
zone assignment has been erased.
In this mode the receiver will not receive any type of transmission.
4.6 Zone Output State
Address 014; Keys [1] to [12] - Default: All Normally Closed
Once a transmitter has been assigned to a zone, you must define whether the
receiver’s zone output will be normally open or normally closed. In address 014
each key represents zone outputs 1 through 12. The associated zone output will be
normally closed if the key is off and if the key is on, the associated zone output will
be normally open. To do so press:
[
ENTER
] + Installer Code + [0] [1] [4] + On/Off status of keys [1] to [12] + [
ENTER
] to
accept or [
CLEAR
] to cancel.
Libeei03.qxd 02/28/2001 11:53 AM Page 14