Paradox Liberator 9000, Руководство по установке

Страница: 4 / 15

4
5
INSTALLATION
2.1 Location & Mounting
Mount the "receiver" on a wall, leaving at least 50mm (2") around the panel box to
permit adequate ventilation/heat dissipation. Select a site that is not susceptible to
drastic changes in temperature and avoid installing the receiving module near or in
the path of strong RF fields, such as neon lights or computers. Also avoid installing
the receiver on or near metal objects, circuit breaker boxes, air conditioners and
heater ducts. As these devices may cause interference, reducing the receiver's
sensitivity. We recommend installing the receiver in a centralized location on the main
floor, avoid installing the receiver in the basement. When selecting an installation site
please take into consideration that the maximum reception distance of the receiver is
1000m/3280ft. (300m/984ft. with 868MHz) in line of sight. To avoid interference,
install the transmitters a minimum of 1.5 meters (5 feet) away from the receiver.
Do not cut, bend or alter the antennas or mount the receiver near or on metal
as this may affect the sensitivity of the receiver!
Firmly screw the two antennas into the connectors marked "
ANT
" on the receiver as
shown in figure 2-1. Using a drill or screwdriver, punch out the four mounting holes
on the back plastic case. Align the six holes of the printed circuit board with the six
pins on the back plastic mounting case and snap into place (see figure 2-1). If
placed correctly, the antennas will lean directly over the groves in the mounting
case. After completing wiring as detailed in sections 2.2 to 2.4, run the wires
through the entry hole on the back plastic case and screw the back of the plastic
case onto the selected installation site. After programming and wiring the receiving
module, affix the plastic cover and screw into place.
2.2 Power Connections
The receiver may be powered by the auxiliary terminals (12V
DC
) of the control panel.
Simply connect the "
AUX
+" terminal of the control panel to the "+12" terminal of the
receiver and the "
AUX
-" of the control panel to the "
GND
" of the receiver (see figure
2-1). If using an external power source please ensure that the "
GND
" of the receiver
and the power source are connected to the "
AUX
-" terminal of the control panel.
Liberator LIB 9002 Wireless PIR:
• Dual Element Sensor
• Auto Pulse Signal Processing (Patented)
• Auto Temperature Compensation
• "No Dead Zone" Standard Lens
• LED Indicators for Detection (red) & Low Battery (yellow)
• Built-in Antenna
• Tamper Switch
• Two 3.6V Lithium "AA" Batteries
Liberator LIB 9020 Wireless Contact Switch:
• Dual High Sensitivity Reed Switch
• External Switch Transmission (Normally Closed)
• Low Battery LED Indicator (yellow)
• Built-in Antenna
• Tamper Switch
• Two 3.6V Lithium "1/2 AA” Batteries
Hand-Held 2-Button Remote Control
• Water Resistant
• Range: 30m (100ft.)
• Battery:Lithium 3V (CR2032)
• Battery Life: Apprx. 1 to 2 years
• Power Transmission: 5mW
• Current Consumption: 18mA (transmission)
Libeei03.qxd 02/28/2001 11:53 AM Page 4