The control panel should be programmed in either of the usual
ways, by means of standard keypad commands or using
Espload from a PC. (Please refer to your panel installation
manual for complete information on panel programming.)
Keypad programming must be conducted at the keypad. Once
control panel programming is complete, enter Keypad
Programming Mode in this way:
Press
[
CLEAR
].
Press
[
ENTER
] [
KEYPAD PROGRAMMING CODE
]
(Default code is
0000
)
A short series of beeps will be emitted by the keypad.
KEYPAD MODE SECTION
: ______
appears in the display.
Enter three digits representing one of the programming
addresses, and program the required information.
Address 000
Day of the Week/Time of Day Programming
The display will read
DAY
: (followed by the currently pro-
grammed day of the week). The 2nd row of the display reads:
press
[1]
to
[7]
. To program the correct day, find the number
corresponding to the day of the week on the list below, and
press the single digit shown for that day, followed by
[
ENTER
]
.
[1]
=
SUN
day
[5]
=
THU
rsday
[2]
=
MON
day
[6]
=
FRI
day
[3]
=
TUE
sday
[7]
=
SAT
urday
[4]
=
WED
nesday
IM639
4
Example:
To program Thursday, in keypad programming
mode, at address
000
, press
[5] [
ENTER
].
After selecting the required day and pressing
[
ENTER
]
, the key-
pad will advance to the time of day setting. The display now
reads
TIME
, followed by the currently programmed time of day.
The second row of the display reads: Enter in 24 Hrs.
To modify the time programmed, enter the four (4) digits corre-
sponding to the required time, according to the 24 hour clock.
After the 4 digits have been entered, you will hear a confirma-
tion beep, indicating that the time programmed has been auto-
matically saved in memory.
Ex.: To program
4:05 p.m
, enter
16:05
by pressing
[1] [6] [0] [5]
.
Once the correct keypad time has been programmed, press
[
ENTER
]
. The LCD display will return to the
KEYPAD MODE SEC
-
TION
: _____
message. Enter the next address.
IMPORTANT:
Panel time
MUST ALSO be programmed.
One-key access programming can be used to set panel time.
Press
[
ENTER
]
, followed by the panels installer, master or user
code 1. Press
[
MEM
],
then enter 2 digits (
00
to
23
) for hours,
and 2 digits (
00
to
59
) for minutes.
Streamline section (001-036, 100-201)
In this section, pressing
[
ENTER
]
saves the data and advances
to the next address automatically. By pressing
[
CLEAR
],
the key-
pad waits for an address: Keypad mode, Section:.
IM639
5
All manuals and user guides at all-guides.com
