Mode Original Message
Characters (#)
All
Section:********
Section:*****###
***Zones*Open***
***Zones*Open###
***Time***:*****
***Time*##:##***
*Pwr*Sup*Lvl*
#Pwr*Sup*Lvl#
***Sun***:******
***Sun*##:##****
***Mon***:******
***Mon*##:##****
***Tue***:******
***Tue*##:##****
***Wed***:******
***Wed*##:##****
***Thu***:******
***Thu*##:##****
***Fri***:******
***Fri*##:##****
***Sat***:******
***Sat*##:##****
Bypass *Zones*Bypass***
#Zones*Bypass###
Memory *Alarm*in*Mem***
*Alarm*in*Mem###
Trouble ****Trouble*****
#***Trouble**###
Teaching
a Keypad Program to Another Keypad
Once the initial keypad in a system has been programmed, all
programmed information can be taught to other keypads by
doing the following:
1- Connect the special serial cable with four-pin connector to
four pins located in bottom left corner of the back of the
master or source 639 keypad. Similarly, connect the other
end of the cable to the four pins on the back of the slave or
destination 639 keypad. The master keypad requires no
other wires at this time; the slave keypad should be con-
nected to a panel.
2- The slave keypad should be in normal operating mode, not
in programming mode.
IM639
18
3- Press
[
ENTER
] [
INSTALLER KEYPAD CODE
] [
TRBL
]
on master
keypad.
4- Wait until the transfer is completed.
The programming information has now been taught to the
second keypad. Disconnect the serial cable and repeat these
steps as required for any additional keypads.
ESPLOAD UPLOAD/DOWNLOAD
This is available on
Espload
2.4 onward. Refer to the following
illustration:
To program a keypad from
Espload
:
1. Connect cable on PC serial port to DB-9 female of LCD
adapter.
2. Connect special serial cable of the keypad between the key-
pad and LCD adapter (keypad must be in normal mode).
3. To download information to a keypad, set the keypad in nor-
mal mode. Press F4 after all messages have been pro-
grammed and select full download.
IM639
19
All manuals and user guides at all-guides.com
all-guides.com
